|
|
20141102_152814
Drilling out the screw. It would move. I'm removing this plate to patch later.
Date: 11/02/2014
Views: 29804
|
|
|
dsc08634
OK now that the plane is off the trailer and on its own wheel we were able to remove most of the trailer hardware and position the ribs. We also used the main bolts to hold the first rib in place. The other rib was left a little lower to be located once
Date: 04/15/2012
Views: 20053
|
|
|
|
p1000629
p1000629.jpg
Date: 02/14/2012
Views: 13668
|
|
|
p1000696
p1000696.jpg
Date: 03/12/2012
Views: 11659
|
|
|
|
dsc09018
Started to make the axle jig. Used a simple setup of first taking large flat blocks of wood and caulking it to the floor somewhere over FS70. Then that allows me to fix the aluminum angle with a single screw once in its final position.
Date: 01/10/2013
Views: 20712
|
|
|
dsc08619
Roap tied to the engine mount frame to hoist the airframe.
Date: 04/14/2012
Views: 36874
|
|
|
|
p1000468
p1000468.jpg
Date: 12/09/2011
Views: 55459
|
|
|
dsc09065
Stbd side peel ply removed.
Date: 01/25/2013
Views: 19145
|
|
|
|
dsc09060
Wetting out stbd side.
Date: 01/24/2013
Views: 17275
|
|
|
nex_2014_01_25_04
Bill helping hoist the aircraft up to remove the jig.
Date: 01/25/2014
Views: 20033
|
|
|
|
dsc08400
Very hard to work in the tunnel and I'm a small guy, 5'11“ 150#
Date: 03/25/2012
Views: 29857
|
|
|
dsc08614
Anybody know a easy way to remove this rust?
Date: 04/10/2012
Views: 29661
|
|
|
|
dsc09056
Wetting out stbd side.
Date: 01/24/2013
Views: 16944
|
|
|
p1000637
p1000637.jpg
Date: 02/14/2012
Views: 11460
|
|
|
|
p1000632
p1000632.jpg
Date: 02/14/2012
Views: 13718
|
|
|
dsc09068
Seeing how ribs 2,3,4 line up. Get a belt sander 4x36, you'll be glad you did. Mine is from Harbor Freight.
Date: 01/25/2013
Views: 19223
|
|
|
|
Wanted to make a copy of B16 to make the cuts on before I cut the actual B16 part.
Wanted to make a copy of B16 to make the cuts on before I cut the actual B16 part.
Date: 04/03/2016
Views: 23870
|
|
|
p1000716
p1000716.jpg
Date: 03/12/2012
Views: 11784
|
|
|
|
p1000635
p1000635.jpg
Date: 02/14/2012
Views: 11692
|
|
|
dsc08605
When I received the plane it had a few areas of this green tape. I guess it was going to be used as a release agent for some sort of jig fabrication. I have found that this 3M stuff works very well.
Date: 04/10/2012
Views: 32245
|
|
