|
IMG_1469p
Cleaned up the tunnel area.
Date: 06/05/2011
Views: 2651
|
|
|
New MC-4A01
2012 04 12 - Well, didn't take very long today to decide the new brake assembly wouldn't fit. It's too long.
Date: 04/11/2012
Views: 2793
|
|
|
IMG_0140post
Date: 09/04/2010
Views: 2429
|
|
|
IMG_0113post
Date: 09/03/2010
Views: 2447
|
|
|
IMG_0146post
Date: 09/04/2010
Views: 2184
|
|
|
IMG_0170post
Date: 09/06/2010
Views: 2624
|
|
|
IMG_0110post
Date: 09/03/2010
Views: 2467
|
|
|
IMG_1287ann
The console cover cut out. Now I have to figure out how to make the cuts for the slots for the brake levers and parking brake. Later there will be cutouts for the flap and trim switches as well as the brake reservoir.
Date: 03/30/2011
Views: 3008
|
|
|
New MC-4A 12
The whole assembly should now fit, length and width, within the existing space. So the unit may be dropped down as needed to allow for it being taller. Due to outside commitments, it looks like it will be Wednesday (18th) before I can get to the hanger
Date: 04/15/2012
Views: 2652
|
|
|
IMG_0164post
Date: 09/05/2010
Views: 2709
|
|
|
IMG_2681
2012 04 09 Well, after 4 weeks and buckets of DOT5 spent trying to make the Jaymar master cylinders work I have given up. They are just crap. So I'm taking the base of their base and building a new brake master setup using MATCO MC-4A master cylinders.
Date: 04/07/2012
Views: 3075
|
|
|
3_Door_Knobs
And low profile screw end that won't catch on the door handle guard plate.
Date: 06/23/2011
Views: 2500
|
|
|
IMG_2598
The culprit seems to be the compressed paper gasket material which dries out if it sits for a while and then leaks. Cork gaskets were recommended as a replacement. Unfortunately, cork gaskets were not available. So I did a Google search and came up wi
Date: 05/30/2012
Views: 2533
|
|
|
IMG_0926ann
Fill/sand on the nose wheel fairing
Date: 03/02/2011
Views: 2207
|
|
|
IMG_1408
Still working on the brake plumbing. The translucent nylon was not fitting properly. Going back to the black stuff.
Date: 05/27/2011
Views: 2759
|
|
|
IMG_1459p
Work continued on the priming/sanding of the repaired areas like the port wing outer flap bracket
Date: 06/05/2011
Views: 2415
|
|
|
IMG_1492p
Began reassembly of the control surfaces. Starboard wing aileron.
Date: 06/18/2011
Views: 2400
|
|
|
IMG_1236ann
Cut along the tape strip.
Date: 03/23/2011
Views: 2647
|
|
|
IMG_1705
May 20 2011, pretty good rain off and on all day. Not much work done.
Date: 05/20/2011
Views: 2585
|
|
|
IMG_0149post
Date: 09/04/2010
Views: 2424
|
|