Date: Monday, August 18 2008 06:00 am From: Kingsley Hurst To: rparigor@suffolk.lib.ny.us Reply-To: Kingsley Hurst Subject: Re: Wing Profiles Attachments: Part 1: noname (TEXT/PLAIN 7bit 834 bytes) Part 2: aerofoildesign-13.pdf (APPLICATION/PDF base64 20658 bytes) Part 3: aerofoildesign-1.pdf (APPLICATION/PDF base64 21020 bytes) Part 4: aerofoildesign-2.pdf (APPLICATION/PDF base64 19944 bytes) Part 5: aerofoildesign-3.pdf (APPLICATION/PDF base64 19066 bytes) Part 6: aerofoildesign-4.pdf (APPLICATION/PDF base64 17390 bytes) Part 7: aerofoildesign-5.pdf (APPLICATION/PDF base64 20330 bytes) Part 8: aerofoildesign-6.pdf (APPLICATION/PDF base64 22460 bytes) Part 9: aerofoildesign-7.pdf (APPLICATION/PDF base64 19562 bytes) Part 10: aerofoildesign-8.pdf (APPLICATION/PDF base64 18556 bytes) Part 11: aerofoildesign-9.pdf (APPLICATION/PDF base64 19780 bytes) Part 12: aerofoildesign-10.pdf (APPLICATION/PDF base64 22620 bytes) Part 13: aerofoildesign-11.pdf (APPLICATION/PDF base64 22978 bytes) Part 14: aerofoildesign-12.pdf (APPLICATION/PDF base64 18344 bytes) Ron, There should be 13 profiles attached numbered from 1 to 13. On opening each, you will note that as well as the number, there is "Cord xxxx" which is the length of the cord in mm for the relevant profile. Profiles 3 to 13 divide the wing into 10 equal parts. If your wing is EXACTLY the correct thickness, profile No 3 should fit the Root of the wing which has a 1270mm (50") cord. No 13 is the tip cord at 1016mm (40") Nos 1 & 2 are slightly bigger than the root profile in case your wing is a little thicker like mine, mine being a Classic is thicker all the way unfortunately. I'm going to make a few more profiles for myself too with these printouts by sticking them to a 3mm thick piece of craftwood. Hope these help Ron. Let me know if you have any problems. Best regards Kingsley