|
IMG_0004post
Date: 08/30/2010
Views: 5618
|
|
|
IMG_0458ann
I've gone back to the build manual and made up a pair of reinforcements. Here marking where the upholstery will be cut to make a place for them.
Date: 10/20/2010
Views: 3041
|
|
|
IMG_1362ann
2010 11 12 Was a total waste of a day. After arriving at the hanger, I went in to open the hanger door. When the hanger door had been opened I was greeted by the sight of a drooping rear bumper on the Ranger. Went to the droopy side and found this. R
Date: 11/12/2010
Views: 4432
|
|
|
IMG_0099post
Date: 09/03/2010
Views: 2733
|
|
|
IMG_2755
New brake master cylinder set, installed and viewed from the tunnel. Brakes have been bled and seem to work well. Taxi testing will tell just how well they work.
Date: 04/24/2012
Views: 3496
|
|
|
IMG_0164post
Date: 09/05/2010
Views: 3030
|
|
|
IMG_0082post
Date: 09/02/2010
Views: 2741
|
|
|
New MC-4A02
And it's too wide to fit in between the mounts. I have 1 1/4 x 1 1/4 x 1/8 Al angle on order to fix the width problem and I think I know how to fix the length problem as well. Then I can address the height issue...
Date: 04/11/2012
Views: 2921
|
|
|
IMG_1589ann
I need to get two brake lines and a reservoir line in there and attached somehow.
Date: 03/15/2011
Views: 3301
|
|
|
IMG_0129post
Date: 09/03/2010
Views: 3132
|
|
|
IMG_0086post
Date: 09/02/2010
Views: 2633
|
|
|
IMG_1667
This had not been done on my quick build cockpit module. Next will be to add the two plies of BID.
Date: 04/13/2011
Views: 2790
|
|
|
IMG_1503ann
Made up a template for cover for the console. It has been pretty chewed up with removal of some stuff and installation of new stuff.
Date: 02/18/2011
Views: 2976
|
|
|
IMG_1423ann
Ran the left and right brake line up through the tunnel.
Date: 12/20/2010
Views: 3458
|
|
|
IMG_1496p
Rudder
Date: 06/18/2011
Views: 2888
|
|
|
Stbd Flap Bracket 1
Received a package of bits for the outer flap brackets from Bud. So back to working on installing the flaps. Starboard outboard flap bracket completed.
Date: 06/28/2011
Views: 2953
|
|
|
IMG_1343ann
2010 11 05 Installed a tail tie-down point where the tailwheel bolt used to be.
Date: 11/05/2010
Views: 2679
|
|
|
IMG_1334ann
2010 10 18 No pics of unloading the Europa at home hanger. But a few days later I had the making for two new work benches to be constructed for the hanger. This is one of the work benches.
Date: 10/08/2010
Views: 2689
|
|
|
IMG_1493p
Port wing aileron
Date: 06/18/2011
Views: 2776
|
|
|
IMG_0152post
Date: 09/04/2010
Views: 2889
|
|