|
IMG_0189[1]
Date: 04/13/2014
Views: 12163
|
|
|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 12993
|
|
|
IMG_0404
Date: 04/17/2015
Views: 9721
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 8737
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 7837
|
|
|
IMG_0190[1]
Date: 04/13/2014
Views: 11296
|
|
|
IMG_0231
Date: 01/31/2014
Views: 10002
|
|
|
IMG_0410
Date: 04/17/2015
Views: 10876
|
|
|
IMG_0279
Insulation going in
Date: 04/02/2014
Views: 10807
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 8806
|
|
|
Ipad 044
Shed Complete
Date: 04/13/2014
Views: 9235
|
|
|
IMG_0406
Date: 04/17/2015
Views: 9065
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 8556
|
|
|
IMG_0187.JPG (2)
Workshop kitted out. All done in 3 weeks!
Date: 04/13/2014
Views: 11118
|
|
|
IMG_0229
At Steve's workshop packing the kit ready for transportation
Date: 01/31/2014
Views: 9452
|
|
|
DSC00149
Winch installed in garage
Date: 09/01/2015
Views: 10662
|
|
|
IMG_0394
Date: 04/10/2015
Views: 8781
|
|
|
IMG_0191[1]
Date: 09/12/2015
Views: 9142
|
|
|
Torque tube
Took some measurements and sent query to Europa. Response was I required the issue 1 TP38s
Date: 09/03/2015
Views: 5720
|
|
|
DSC00214
blue foam placed in rudder to fill void
Date: 09/08/2015
Views: 10437
|
|