|
dsc09063
Hey Bill!
Date: 01/24/2013
Views: 8847
|
|
|
dsc09067
dsc09067.jpg
Date: 01/25/2013
Views: 9073
|
|
|
dsc09050
Stbd. side ready for the bid.
Date: 01/24/2013
Views: 8551
|
|
|
dsc09040
The gap from the bottom of the socket and the belly is as you see. The only way to get it all the way down was to lower the belly to 15" which was not considered an option. Belly hight is 16.0" with the axle width at 82.50" and axle cent
Date: 01/23/2013
Views: 10057
|
|
|
dsc08963
Port side. LG socket fitting.
Date: 10/01/2012
Views: 10420
|
|
|
20141102_153539
Out. Ad you can see the screw is sill in the nut plate. it came out later.
Date: 11/02/2014
Views: 19118
|
|
|
20141102_161036
Everything looking good.
Date: 11/02/2014
Views: 16542
|
|
|
dsc09034
Starboard side done. Pic taken before a little clean up.
Date: 01/22/2013
Views: 8353
|
|
|
dsc08631
More of the same.
Date: 04/14/2012
Views: 7979
|
|
|
nex_2014_01_25_31
Starboard side, need to trim the bolt.
Date: 01/26/2014
Views: 9167
|
|
|
photo (2)
Small area to work in. Back was killing me after that job. can't wait to give my back the same treatment when doing the ribs and starboard side.
Date: 08/20/2012
Views: 14021
|
|
|
dsc09032
Port side done.
Date: 01/22/2013
Views: 8548
|
|
|
dsc08662
The 10“ diameter from the pilot hole.
Date: 04/22/2012
Views: 13235
|
|
|
dsc09039
Port side done after cure.
Date: 01/23/2013
Views: 9259
|
|
|
nex_2014_01_12_05
Port side top.
Date: 01/13/2014
Views: 7944
|
|
|
nex_2014_01_12_07
Port side.
Date: 01/13/2014
Views: 7984
|
|
|
dsc08633
We had to put the plane somewhat down near the trailer with the main up so that we could get the right contour for the ribs. Reminds me of a B-17 with the main just showing.
Date: 04/14/2012
Views: 8444
|
|
|
dsc09068
Seeing how ribs 2,3,4 line up. Get a belt sander 4x36, you'll be glad you did. Mine is from Harbor Freight.
Date: 01/25/2013
Views: 10016
|
|
|
nex_2014_01_25_32
nex_2014_01_25_32.jpg
Date: 01/26/2014
Views: 10072
|
|
|
dsc09070
While the layups are curing we stared work on the axles. Had to ream out the holes forMG02.
Date: 01/25/2013
Views: 9009
|
|