|
IMG_6967post
Starboard side juncture of main beam with cross beam.
Date: 12/27/2009
Views: 3107
|
|
|
IMG_0918post
Some pics after the engine run-up and taxi tests today.
Date: 07/01/2010
Views: 3839
|
|
|
IMG_6972post
Pointing out areas relieved for fit over swing arm
Date: 12/27/2009
Views: 3123
|
|
|
OregonAero00small
Date: 07/19/2005
Views: 3190
|
|
|
IMG_9534ann
Date: 06/03/2010
Views: 3165
|
|
|
IMG_6704Ann
Date: 02/15/2008
Views: 3558
|
|
|
DSCN6107Ann
Date: 06/13/2007
Views: 3164
|
|
|
1_snaps
The snap bases for the seat back cushions were poorly installed by my interior guy. Just a skinny screw through the over-sized hole the snap base where the original rivet went.
Date: 06/23/2011
Views: 4648
|
|
|
DSCN4667small
Date: 08/27/2006
Views: 3850
|
|
|
LongRangeTank
Date: 07/31/2004
Views: 4905
|
|
|
IMG_1086ann
Back in early April I attempted to bolt the new Billet Pump onto the gearbox. Problem #1 - It didn't fit the boss on the gearbox. It hit a raised area at the edge of the boss.
Date: 04/03/2010
Views: 3589
|
|
|
IMG_1195ann
Date: 05/31/2010
Views: 3492
|
|
|
DSCN6100Ann
Date: 06/13/2007
Views: 3701
|
|
|
IMG_0045post
Put a bit of fluid in the reservoir and observe bubbles. Air is being pushed out and replaced by fluid. That's good. Watched this for almost an hour till the bubbles stopped and the reservoir began to fill. Shut the bleed contraption, stuff the line b
Date: 07/08/2010
Views: 4102
|
|
|
IMG_1238ann
The vent port was reversed from the original regulator. This one points forward. Had to do some tugging on tubing to get it all arranged. As soon as I have my new brake caliper installed and tested, I'll be ready to start testing the engine.
Date: 06/21/2010
Views: 3512
|
|
|
IMG_6696Ann
Date: 02/15/2008
Views: 3603
|
|
|
IMG_1193ann
Date: 05/31/2010
Views: 3306
|
|
|
Condition Inspection P3 T
Date: 02/04/2010
Views: 3289
|
|
|
IMG_6966post
Port side juncture of main beam with cross beam.
Date: 12/27/2009
Views: 3333
|
|
|
OutsideClosed
Date: 07/09/2003
Views: 4887
|
|