|
IMG_0340[1]
cloth cabinet installed.
Date: 09/04/2014
Views: 14671
|
|
|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 13592
|
|
|
IMG_0412
Date: 04/17/2015
Views: 9665
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 9225
|
|
|
IMG_0414
Date: 04/18/2015
Views: 10745
|
|
|
Ipad 041
Shed Under construction
Date: 03/27/2014
Views: 9232
|
|
|
IMG_0821
Trial fitted the torque tube but it looks like the TP38 bearing is too short!
Date: 09/03/2015
Views: 8020
|
|
|
Torque tube
Took some measurements and sent query to Europa. Response was I required the issue 1 TP38s
Date: 09/03/2015
Views: 5917
|
|
|
DSC00158
Date: 09/03/2015
Views: 13558
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 9145
|
|
|
IMG_0245
Wife not happy. Aircraft parts in the house!
Date: 02/01/2014
Views: 9927
|
|
|
DSC00229
Still some work to do but happy so far.
Date: 09/10/2015
Views: 13680
|
|
|
IMG_0344[1]
Aircraft parts & Documents stored
Date: 09/04/2014
Views: 10351
|
|
|
IMG_0392
Date: 04/10/2015
Views: 8721
|
|
|
IMG_0389
Rear Bulk head fixed and peel plyed
Date: 04/10/2015
Views: 8825
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 8937
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 13637
|
|
|
IMG_0390
Date: 04/10/2015
Views: 8890
|
|
|
IMG_0408
Date: 04/17/2015
Views: 9241
|
|
|
DSC00215
foam removed to make space for the rudder bracket
Date: 09/09/2015
Views: 9878
|
|