|
IMGA0657
After repair
Date: 04/17/2013
Views: 7638
|
|
|
IMGA0613
Date: 04/09/2013
Views: 11720
|
|
|
IMGA0680
These are the rear blocks where the bell cranks sit in. Note the vent holes
Date: 04/18/2013
Views: 7142
|
|
|
IMGA0623
Date: 04/09/2013
Views: 8450
|
|
|
IMGA0716
Cracked off the jig, flipped over, and there we go iv got half a wing!!
Date: 04/23/2013
Views: 7081
|
|
|
IMGA0722
Just testing out the rear blocks for an idea what it will look like
Date: 04/24/2013
Views: 7420
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 7443
|
|
|
IMGA0820
Aileron closeout
Date: 05/15/2013
Views: 9508
|
|
|
IMGA0571
Date: 03/17/2013
Views: 25283
|
|
|
IMGA0701
First wings L.E layed up and peel plyed. The blue foam is keeping in place a 90 degree strip which is keeping the end of the uni cloth bent under to aid bonding to the rear of the spar. A helpful tip from Mike Gregory.......Oh wanted to say it took 8 and
Date: 04/20/2013
Views: 7355
|
|
|
IMGA0589
Date: 03/29/2013
Views: 11212
|
|
|
IMGA0833
Remove trailing edge support ready for skin lay up
Date: 05/17/2013
Views: 8770
|
|
|
IMGA0626
Hole ready for stall warner
Date: 04/11/2013
Views: 7921
|
|
|
IMGA0785
One side done. A straight edge is bonded on to aid rigidity once some of the foam is cut away
Date: 05/12/2013
Views: 7802
|
|
|
IMGA1030
Wing tips prepped for shaping thanks to Tony K's web blog on his kit #272
Date: 08/08/2013
Views: 8038
|
|
|
IMGA0573
Date: 03/17/2013
Views: 9991
|
|
|
IMGA0585
Date: 03/18/2013
Views: 10668
|
|
|
IMGA0712
Made some stands and a reference plate which is at 90 degrees to the spar
Date: 04/23/2013
Views: 7847
|
|
|
IMGA0620
Date: 04/09/2013
Views: 8303
|
|
|
IMGA0641
EXOTHERM!! My worst moment yet
Date: 04/16/2013
Views: 7463
|
|