|
dsc08399
Atempting to remove the mass ballance brace but to only find out later that it is bonded at the top.
Date: 03/25/2012
Views: 9532
|
|
|
dsc08964
Port side. Fitting of LG socket.
Date: 10/01/2012
Views: 10187
|
|
|
p1000727
p1000727.jpg
Date: 03/12/2012
Views: 6431
|
|
|
nex_2014_01_25_02
Starboard side of the air bubble fix on rib one. Used Flox with aeroboxy as a fillit.
Date: 01/25/2014
Views: 8207
|
|
|
dsc08664
The gell coat really gums up the sand paper. Still a bit more to remove.
Date: 04/22/2012
Views: 14158
|
|
|
dsc08603
Since I'm going to have to remove the mono wheel I dont have much of an edge to close in the big hole in the bottom. I'll have a better look at it once its a tri-gear.
Date: 04/10/2012
Views: 12002
|
|
|
20141102_161036
Everything looking good.
Date: 11/02/2014
Views: 16571
|
|
|
p1000695
p1000695.jpg
Date: 03/12/2012
Views: 6191
|
|
|
p1000701
p1000701.jpg
Date: 03/12/2012
Views: 6425
|
|
|
nex_2014_01_25_17
Rolled out on the grass. Notice the tail wheel is still there. I left it in due to not having the stacks of cash to hold the nose down.
Date: 01/26/2014
Views: 8397
|
|
|
dsc08401
I see you!
Date: 03/25/2012
Views: 9171
|
|
|
p1000723
p1000723.jpg
Date: 03/12/2012
Views: 6919
|
|
|
dsc09034
Starboard side done. Pic taken before a little clean up.
Date: 01/22/2013
Views: 8361
|
|
|
dsc08630
Though this was a neat pic of the mono wheel in the retracted position.
Date: 04/14/2012
Views: 8073
|
|
|
p1000627
p1000627.jpg
Date: 02/14/2012
Views: 7700
|
|
|
p1000720
p1000720.jpg
Date: 03/12/2012
Views: 7257
|
|
|
p1000706
p1000706.jpg
Date: 03/12/2012
Views: 6185
|
|
|
dsc09073
Rib 2 template.
Date: 01/26/2013
Views: 9233
|
|
|
dsc09060
Wetting out stbd side.
Date: 01/24/2013
Views: 8982
|
|
|
Close up of the relief cut.
Close up of the relief cut.
Date: 04/03/2016
Views: 14184
|
|