Brackets are mounted. Wayne is about half way done with PCB.
Date: 07/15/2010
Views: 3492
DSCF0007_001
Date: 07/27/2009
Views: 3446
CH8_1
Date: 12/31/1969
Views: 5815
Newest Image
EAA SITE
Date: 08/23/2023
Views: 165837
FlapDrive17aAnn
After the usual Sunday morning work and a few errands, I managed to get back out to the shop to complete the assembly and test of the flap drive. With the two washers glued in, the assembly of the flap drive rod to the cross tube went easily. Yes, the nut is not fully tight. It won't be tightened until the final check with the wings on to be certain that full flap extension/retraction is confirmed.