|
IMG_6788post
Length of the cross I-beam
Date: 12/10/2009
Views: 3533
|
|
|
Intercooler06
Date: 01/07/2006
Views: 4142
|
|
|
SideClosed
Date: 07/09/2003
Views: 4828
|
|
|
IMG_0920post
Some pics after the engine run-up and taxi tests today.
Date: 07/01/2010
Views: 5110
|
|
|
IntercoolerFig1
Date: 01/07/2006
Views: 4277
|
|
|
DSCN6091Ann
Date: 06/12/2007
Views: 3552
|
|
|
IMG_6967post
Starboard side juncture of main beam with cross beam.
Date: 12/27/2009
Views: 3151
|
|
|
IMG_7440post
2010 03 19 - Checked to see if the new brake banjo hardware would work while completing the Annual Condition Inspection on the Europa. This is a comparison of the original fitting from the brake with the new banjo bolt that's supposed to work. Close, bu
Date: 03/19/2010
Views: 3391
|
|
|
IMG_6788small
Date: 02/23/2008
Views: 3673
|
|
|
Mod70_EX08Ann
Date: 07/05/2005
Views: 3717
|
|
|
IMG_2854
Date: 12/03/2008
Views: 3392
|
|
|
IMG_0916post
Safety wired the bolts and check the installation. Pushed the aircraft and the brake stopped it. Held the brake and tried to push it aircraft. It wouldn't budge. Very good. Pulled it out of the hanger, started it up, let it warm properly and taxi tes
Date: 07/01/2010
Views: 5334
|
|
|
IMG_9569post
A side view of the installation. Tomorrow I'll be trying to complete the installation of the new control column mounted brake master cylinder. If that is done and I have working brakes, we may try an engine run.
Date: 06/12/2010
Views: 4251
|
|
|
IMG_1087ann
Then problem #2 - bolts that held the cover plate in place wouldn't fit into the space provided on the pump.
Date: 04/03/2010
Views: 3780
|
|
|
IMG_6972post
Pointing out areas relieved for fit over swing arm
Date: 12/27/2009
Views: 3188
|
|
|
IMG_7530ann
First try was just to bolt the BSPP banjo onto the brake. Needless to say, that was just too simple to work. It wouldn't seat properly in the BSPT brake.
Date: 04/18/2010
Views: 3303
|
|
|
IMG_7541ann
It took almost an hour to carefully and safely get the tap started in the aluminum brake. I sure didn't want to screw that up. Once I had a good start and the tap began to cut, I clamped the tap in the vice with the brake held high so chips fall out and
Date: 04/18/2010
Views: 3109
|
|
|
LongRangeTankPort
Date: 07/31/2004
Views: 4150
|
|
|
IMG_1195ann
Date: 05/31/2010
Views: 3558
|
|
|
IMG_2858
Date: 12/03/2008
Views: 3643
|
|