|
IMGA0620
Date: 04/09/2013
Views: 8184
|
|
|
IMGA0573
Date: 03/17/2013
Views: 9863
|
|
|
IMGA0754
These straps are great, one down one to go
Date: 05/05/2013
Views: 7386
|
|
|
IMGA0770
Two are a time baby yeah!!!!!
Date: 05/10/2013
Views: 7442
|
|
|
IMGA0641
EXOTHERM!! My worst moment yet
Date: 04/16/2013
Views: 7372
|
|
|
IMGA0785
One side done. A straight edge is bonded on to aid rigidity once some of the foam is cut away
Date: 05/12/2013
Views: 7676
|
|
|
IMGA0657
After repair
Date: 04/17/2013
Views: 7535
|
|
|
IMGA0707
The next day me and my helper Ang did the other wing. This time it only took 6 and half hours so left us time to trim the other wing
Date: 04/21/2013
Views: 7188
|
|
|
IMGA0701
First wings L.E layed up and peel plyed. The blue foam is keeping in place a 90 degree strip which is keeping the end of the uni cloth bent under to aid bonding to the rear of the spar. A helpful tip from Mike Gregory.......Oh wanted to say it took 8 and
Date: 04/20/2013
Views: 7253
|
|
|
IMGA1259
Not bad looking for a classic wing if i do say so myself. Had to make a wing dolly for easier manoeuvrability round the shop.
Date: 09/23/2013
Views: 20393
|
|
|
IMGA0664
Scrap bit of foam which will get sanded to match the profile of the block. It takes up the gap between spar and end of the block
Date: 04/17/2013
Views: 7233
|
|
|
IMGA1030
Wing tips prepped for shaping thanks to Tony K's web blog on his kit #272
Date: 08/08/2013
Views: 7915
|
|
|
IMGA0716
Cracked off the jig, flipped over, and there we go iv got half a wing!!
Date: 04/23/2013
Views: 6991
|
|
|
IMGA0572
Date: 03/17/2013
Views: 8901
|
|
|
IMGA0581
Date: 03/18/2013
Views: 10180
|
|
|
IMGA0878
Wing rib close outs
Date: 05/30/2013
Views: 8409
|
|
|
IMGA0680
These are the rear blocks where the bell cranks sit in. Note the vent holes
Date: 04/18/2013
Views: 7049
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 7338
|
|
|
IMGA0589
Date: 03/29/2013
Views: 11071
|
|
|
IMGA0712
Made some stands and a reference plate which is at 90 degrees to the spar
Date: 04/23/2013
Views: 7744
|
|