|
dsc09045
Uncle Kim at work. We would tilt to starboard to work on the port side vice versa.
Date: 01/23/2013
Views: 8997
|
|
|
p1000710
p1000710.jpg
Date: 03/12/2012
Views: 6163
|
|
|
dsc09064
Bill does nice peel ply work!
Date: 01/24/2013
Views: 8101
|
|
|
E1
[quote="Bud Yerly"]"Make a glass cover that fits the hole out of three sheets of bid laid up on a flat surface. After cure, hold it up to the bottom of the plane and mark the contour. Cut and approximate the fit. It should be near level
Date: 10/05/2012
Views: 11466
|
|
|
dsc09072
Here is a shot of the working angle. This was so much better than leaning over the edge. Kim's idea. Notice the heater behind Kim, this was key to keeping the temps even though the temps outside were in the 40's.
Date: 01/26/2013
Views: 8247
|
|
|
p1000687
p1000687.jpg
Date: 03/12/2012
Views: 6704
|
|
|
dsc09037
Making a template for rib 2. Do yourself a favor and do not use the templates in the manual you will end up waisting your plywood, just make your own.
Date: 01/23/2013
Views: 8346
|
|
|
nex_2014_01_25_32
nex_2014_01_25_32.jpg
Date: 01/26/2014
Views: 8972
|
|
|
dsc09070
While the layups are curing we stared work on the axles. Had to ream out the holes forMG02.
Date: 01/25/2013
Views: 8119
|
|
|
DSC08801
starboard side
Date: 06/05/2012
Views: 9457
|
|
|
20141102_161049
20141102_161049.jpg
Date: 11/02/2014
Views: 13906
|
|
|
20141102_161036
Everything looking good.
Date: 11/02/2014
Views: 14734
|
|
|
dsc08607
Starting to prep the bays for the tri-gear conversion.
Date: 04/10/2012
Views: 9438
|
|
|
p1000709
p1000709.jpg
Date: 03/12/2012
Views: 6454
|
|
|
p1000698
p1000698.jpg
Date: 03/12/2012
Views: 6890
|
|
|
20141102_161000
template for new firewall.
Date: 11/02/2014
Views: 15484
|
|
|
dsc08622
Removed.
Date: 04/14/2012
Views: 16587
|
|
|
p1000685
p1000685.jpg
Date: 03/12/2012
Views: 6187
|
|
|
dsc09047
I took cardboard and bent it around the socket and overlapped per the manual. Then took this cardboard and made a new template for cutouts. This made the layups go really quick.
Date: 01/23/2013
Views: 8300
|
|
|
p1000616
p1000616.jpg
Date: 01/29/2012
Views: 9467
|
|