|
IMG_7267post
Date: 02/21/2010
Views: 3248
|
|
|
IMG_7268post
Date: 02/21/2010
Views: 4036
|
|
|
IMG_7269post
Date: 02/21/2010
Views: 3514
|
|
|
1_Door_Knobs
The new door knob mounting hardware is a stainless steel "binding post" acquired from McMaster-Carr. These things are available in myriad materials and sizes. There just happened to be a perfect size in the stainless steel variety which I pref
Date: 06/23/2011
Views: 4602
|
|
|
IMG_6967post
Starboard side juncture of main beam with cross beam.
Date: 12/27/2009
Views: 3157
|
|
|
DSCN4665small
Date: 08/27/2006
Views: 4009
|
|
|
DSCN6125Ann
Date: 06/14/2007
Views: 3229
|
|
|
Condition Inspection P1 T
Date: 02/04/2010
Views: 3213
|
|
|
IMG_1167ann
Went to the hanger after work and put the brake back together. Seems to work fine. I have not safety wired it yet as I want to add fluid, bleed and give it a good test beforehand. When all tests wel,l with no leaks, I'll wire it up. Could have used a
Date: 04/19/2010
Views: 3273
|
|
|
IMG_7539ann
Realizing that I'd need to do any remaining work at home, I removed the disk brake, gathered up the bits and headed for the shop. This is just a pic of the BSPT threaded hole in the disk brake. Had to clean it out as it was full of crap. Testing showed
Date: 04/18/2010
Views: 3157
|
|
|
Intercooler07
Date: 01/07/2006
Views: 4274
|
|
|
IMG_6699Ann
Date: 02/15/2008
Views: 3974
|
|
|
IMG_7429post
Here's a closeup of the hose end, bolt and washers. The hose end connector is identical to that which was on the master cylinder end so this should easily replace the 90 degree AN hose end provided. We'll know better later this week when I can get to th
Date: 03/15/2010
Views: 3051
|
|
|
DSCN6120Ann
Date: 06/14/2007
Views: 3039
|
|
|
Intercooler08
Date: 01/07/2006
Views: 4199
|
|
|
DSCN6109Ann
Date: 06/13/2007
Views: 3532
|
|
|
LongRangeTankStbd
Date: 07/31/2004
Views: 4309
|
|
|
3_snaps
The original snap base hardware is on the right. The new snap bases and mounting hardware are on the left. These 6-32 screw mount snap bases are from McMaster-Carr. I used big ol' AN970 washers for more support underneath and nyloc nuts so they don't c
Date: 06/23/2011
Views: 4294
|
|
|
DSCN6103Ann
Date: 06/13/2007
Views: 3797
|
|
|
IMG_1237ann
The new regulator is 25 psi. Should be plenty of pressure available to feed the 914.
Date: 06/21/2010
Views: 3631
|
|