|
IMG_0190post
Date: 09/08/2010
Views: 3021
|
|
|
IMG_1275ann
2011 03 29 Weather has turned cold again. No hanger work for a few days. Working in the shop on the wheel pants. The nose gear pant with mounting flange for the front piece
Date: 03/29/2011
Views: 3305
|
|
|
IMG_1242ann
The only problem is that 1" spacers (1" sq tube) don't provide sufficient space for the caliper to move.
Date: 03/25/2011
Views: 2936
|
|
|
IMG_0106post
Date: 09/03/2010
Views: 2797
|
|
|
IMG_1492p
Began reassembly of the control surfaces. Starboard wing aileron.
Date: 06/18/2011
Views: 2825
|
|
|
IMG_0241post
Date: 09/12/2010
Views: 6678
|
|
|
IMG_0101post
Date: 09/03/2010
Views: 2827
|
|
|
IMG_1677
Still need adjustments on the parking brake wheel slot and brake lever slots.
Date: 04/29/2011
Views: 2590
|
|
|
IMG_1408
Still working on the brake plumbing. The translucent nylon was not fitting properly. Going back to the black stuff.
Date: 05/27/2011
Views: 3448
|
|
|
IMG_0150post
Date: 09/04/2010
Views: 2944
|
|
|
IMG_1482p
Drilled starboard side bracket
Date: 06/08/2011
Views: 3052
|
|
|
IMG_0109post
Date: 09/03/2010
Views: 2828
|
|
|
IMG_3374em
Run the engine, check the pressures. All seems OK. 5 lbs into the regulator and 3.8 lbs out of the regulator. This is with the Billet mechanical pump. Which became the next source of concern.
Date: 07/04/2012
Views: 3736
|
|
|
IMG_0209post
Date: 09/08/2010
Views: 3190
|
|
|
IMG_2598
The culprit seems to be the compressed paper gasket material which dries out if it sits for a while and then leaks. Cork gaskets were recommended as a replacement. Unfortunately, cork gaskets were not available. So I did a Google search and came up wi
Date: 05/30/2012
Views: 3059
|
|
|
IMG_0102post
Date: 09/03/2010
Views: 2798
|
|
|
IMG_1396
Had to shorten the new intercooler hose to allow everything to move to port. Repositioned the aluminum baffle and the intercooler and all fits now.
Date: 05/26/2011
Views: 3166
|
|
|
New MC-4A02
And it's too wide to fit in between the mounts. I have 1 1/4 x 1 1/4 x 1/8 Al angle on order to fix the width problem and I think I know how to fix the length problem as well. Then I can address the height issue...
Date: 04/11/2012
Views: 2969
|
|
|
IMG_0078post
Date: 09/01/2010
Views: 2820
|
|
|
IMG_0155post
Date: 09/04/2010
Views: 3280
|
|