|
dsc09045
Uncle Kim at work. We would tilt to starboard to work on the port side vice versa.
Date: 01/23/2013
Views: 9852
|
|
|
DSC08797
Port side
Date: 06/05/2012
Views: 10295
|
|
|
p1000711
p1000711.jpg
Date: 03/12/2012
Views: 6676
|
|
|
nex_2014_01_25_31
Starboard side, need to trim the bolt.
Date: 01/26/2014
Views: 9007
|
|
|
dsc08631
More of the same.
Date: 04/14/2012
Views: 7868
|
|
|
nex_2014_01_25_02
Starboard side of the air bubble fix on rib one. Used Flox with aeroboxy as a fillit.
Date: 01/25/2014
Views: 8073
|
|
|
p1000470
p1000470.jpg
Date: 12/09/2011
Views: 11882
|
|
|
p1000704
p1000704.jpg
Date: 03/12/2012
Views: 6225
|
|
|
dsc09056
Wetting out stbd side.
Date: 01/24/2013
Views: 8450
|
|
|
dsc08628
Nic pic of the plane! If Bill would move his head out of the way! Notice I'm using a bungee cord to hold the doors open.
Date: 04/14/2012
Views: 9416
|
|
|
dsc08608
These will have to go. They are on top and I will remove them and put one vent on the bottom.
Date: 04/10/2012
Views: 12844
|
|
|
dsc08662
The 10“ diameter from the pilot hole.
Date: 04/22/2012
Views: 13116
|
|
|
p1000635
p1000635.jpg
Date: 02/14/2012
Views: 6852
|
|
|
dsc09054
Wetting out stbd side.
Date: 01/24/2013
Views: 8470
|
|
|
p1000701
p1000701.jpg
Date: 03/12/2012
Views: 6390
|
|
|
nex_2014_01_25_06
Mains on the ground for the first time.
Date: 01/25/2014
Views: 7948
|
|
|
dsc08630
Though this was a neat pic of the mono wheel in the retracted position.
Date: 04/14/2012
Views: 7938
|
|
|
p1000473
p1000473.jpg
Date: 12/13/2011
Views: 13949
|
|
|
2012-08-18_19-58-42_666
Port side. Same area as before just without the flash. Backlit from the inside to show areas with less material. This is before I did the belly layup per the manual.
Date: 08/19/2012
Views: 11954
|
|
|
dsc09072
Here is a shot of the working angle. This was so much better than leaning over the edge. Kim's idea. Notice the heater behind Kim, this was key to keeping the temps even though the temps outside were in the 40's.
Date: 01/26/2013
Views: 9113
|
|