|
IMG_0003ann
Date: 08/30/2010
Views: 5728
|
|
|
IMG_1689
Getting closer.
Date: 05/10/2011
Views: 2914
|
|
|
6_snaps
Seats reinstalled in the cockpit. Snap tabs to the headrests work great now. A bit more detail is available in the Modifications album
Date: 06/23/2011
Views: 2872
|
|
|
IMG_0025post
Date: 08/30/2010
Views: 4346
|
|
|
IMG_0242post
Date: 09/12/2010
Views: 2453
|
|
|
IMG_0088post
Date: 09/02/2010
Views: 2774
|
|
|
2_snaps
The snap bases pulled off the screws first time the seat back was removed.
Date: 06/23/2011
Views: 2918
|
|
|
IMG_1668
Began fitting the brake fluid reservoir.
Date: 04/13/2011
Views: 3150
|
|
|
IMG_0162post
Date: 09/05/2010
Views: 2741
|
|
|
IMG_0004post
Date: 08/30/2010
Views: 5572
|
|
|
IMG_1446ann
Final brake plumbing and other stuff installed below the tunnel.
Date: 06/04/2011
Views: 2911
|
|
|
IMG_0926ann
Fill/sand on the nose wheel fairing
Date: 03/02/2011
Views: 2582
|
|
|
New MC-4A 08
With the mounting holes drilled and the sides cut away the brackets are attached to the mount.
Date: 04/15/2012
Views: 2899
|
|
|
IMG_3331em
Turn the plugs over and one plug on #3 looks funny. Calls for a closer look...
Date: 06/12/2012
Views: 3560
|
|
|
IMG_2692
The longest AN3-30 bolt I had was too short so a longer bolt is on order as are aluminum spacers to maintain proper alignment of the ends of the MCs.
Date: 04/09/2012
Views: 3131
|
|
|
IMG_1320
View showing reservoir, trim switch, hole for flap switch
Date: 04/15/2011
Views: 3172
|
|
|
IMG_0040post
Date: 09/01/2010
Views: 3506
|
|
|
IMG_0238post
Date: 09/11/2010
Views: 2514
|
|
|
IMG_0924ann
Seems like these are the correct holes for the new Riv-Nuts. I hope so anyway.
Date: 03/02/2011
Views: 4384
|
|
|
IMG_3540em
While the airbox was off, I again check all the pressure hoses to the carbs. Oh, what have we here. BIG leaks in the pressure lines to the carb bowls. Two leaks like this. Not observed before because the fittings were tied to that fuel line and the sp
Date: 07/30/2012
Views: 6089
|
|