|
DSC00153
Lathe installed
Date: 09/01/2015
Views: 11263
|
|
|
DSC00149
Winch installed in garage
Date: 09/01/2015
Views: 11147
|
|
|
IMG_0344[1]
Aircraft parts & Documents stored
Date: 09/04/2014
Views: 10505
|
|
|
IMG_0340[1]
cloth cabinet installed.
Date: 09/04/2014
Views: 15080
|
|
|
IMG_0187[1]
Started to fit fixtures and fittings
Date: 04/13/2014
Views: 12568
|
|
|
IMG_0189[1]
Date: 04/13/2014
Views: 12860
|
|
|
IMG_0190[1]
Date: 04/13/2014
Views: 11973
|
|
|
IMG_0191[1]
Date: 09/12/2015
Views: 9695
|
|
|
DSC00229
Still some work to do but happy so far.
Date: 09/10/2015
Views: 14377
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 9347
|
|
|
DSC00219
bracket installed
Date: 09/09/2015
Views: 11622
|
|
|
DSC00214
blue foam placed in rudder to fill void
Date: 09/08/2015
Views: 11371
|
|
|
DSC00215
foam removed to make space for the rudder bracket
Date: 09/09/2015
Views: 10301
|
|
|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 14313
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 8267
|
|
|
Torque tube
Took some measurements and sent query to Europa. Response was I required the issue 1 TP38s
Date: 09/03/2015
Views: 6070
|
|
|
DSC00155
As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.
Date: 09/03/2015
Views: 8393
|
|
|
IMG_0821
Trial fitted the torque tube but it looks like the TP38 bearing is too short!
Date: 09/03/2015
Views: 8233
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 14347
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 9665
|
|