|
Clevis Fork dimensions after material removal
Date: 12/16/2013
Views: 4373
|
|
|
Heims overall length cut down to 1.700"
Date: 12/16/2013
Views: 3865
|
|
|
Emergency Maneuver that starts with Heim? 1 of 13
Date: 12/16/2013
Views: 4582
|
|
|
Emergency Maneuver that starts with Heim? 2 of 13
Date: 12/16/2013
Views: 4645
|
|
|
Front threaded rod cut down to .450 (I aim for minimum of 9.5 threads of engagement on any 5/16-24 joint)
Date: 12/13/2013
Views: 4214
|
|
|
Rod end clevis fork ground down to 1.975" (again minimum 9.5 threads of engagement)
Date: 12/13/2013
Views: 5068
|
|
|
Length of coupler is ~ .855" cut down from 1". 9.5 times two is 19, so this allows minimum of 19 threads of engagement
Date: 12/13/2013
Views: 3624
|
|
|
Temporary mount using 1 flat head 1/4-28
Date: 12/13/2013
Views: 3761
|
|
|
The threaded portion of my "thunk" fits nicely inside this spacer
Date: 12/13/2013
Views: 4119
|
|
|
The 11/16-16 thread is not too common
Date: 12/13/2013
Views: 3537
|
|
|
I will leave ~ 1.25 diameters of thread engaging and remove all else
Date: 12/13/2013
Views: 3735
|
|
|
What an idiot, I turned off half the nut down to spacer OD to save a little weight
Date: 12/13/2013
Views: 3647
|
|
|
You can see I left a little space so the spacer can pinch the bearing when the nut is tightened
Date: 12/13/2013
Views: 3989
|
|
|
I'm going to Redux the nut in place and Redux/Flox the thread extender hang-over
Date: 12/13/2013
Views: 3737
|
|
|
1/2" ball end-mill on order (McMaster) to to mill a pocket in the brake master cylinder directly above the mounting holes
Date: 12/13/2013
Views: 4285
|
|
|
Using fore and aft the supplied by Europa for push-rod jam nuts that are .155" thick
Date: 12/13/2013
Views: 3524
|
|
|
The magic number is 1.990" from the forward pillow block bearing to the grove.
Date: 12/13/2013
Views: 4422
|
|
|
You can see the pillow block is aft of the threads
Date: 12/13/2013
Views: 4427
|
|
|
Aft mount
Date: 12/13/2013
Views: 3758
|
|
|
Overall view of front mount
Date: 12/13/2013
Views: 3984
|
|