|
IMG_0191[1]
Date: 09/12/2015
Views: 9174
|
|
|
IMG_0821
Trial fitted the torque tube but it looks like the TP38 bearing is too short!
Date: 09/03/2015
Views: 7809
|
|
|
DSC00160
Foam removed from rear bulk head ready for plywood inserts
Date: 09/03/2015
Views: 10188
|
|
|
DSC00215
foam removed to make space for the rudder bracket
Date: 09/09/2015
Views: 9501
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 8856
|
|
|
IMG_0230
Date: 01/31/2014
Views: 9474
|
|
|
IMG_0391
Date: 04/10/2015
Views: 8889
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 13011
|
|
|
IMG_0251
Kit safely in Storage.
Date: 02/01/2014
Views: 9395
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 8593
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 8773
|
|
|
DSC00219
bracket installed
Date: 09/09/2015
Views: 10542
|
|
|
Ipad 039
Concrete base for 20ft x 10ft shed
Date: 03/22/2014
Views: 8194
|
|
|
IMG_0412
Date: 04/17/2015
Views: 9442
|
|
|
DSC00153
Lathe installed
Date: 09/01/2015
Views: 10757
|
|
|
IMG_0390
Date: 04/10/2015
Views: 8715
|
|
|
IMG_0229
At Steve's workshop packing the kit ready for transportation
Date: 01/31/2014
Views: 9492
|
|
|
IMG_0414
Date: 04/18/2015
Views: 10515
|
|
|
IMG_0279
Insulation going in
Date: 04/02/2014
Views: 10852
|
|
|
Ipad 044
Shed Complete
Date: 04/13/2014
Views: 9269
|
|