|
IMG_1244ann
The overall fit for the wheel pant is good. Need to make a hole and cutout to properly locate the wheel pant.
Date: 03/25/2011
Views: 2949
|
|
|
IMG_0457ann
2010 10 20 While in Florida, I had Bud go over the aircraft to see what issues he could find. One issue was the lack of spar pin reinforcements when the cockpit module was built.
Date: 10/20/2010
Views: 3197
|
|
|
IMG_3290post
Here you can see where the gasket was cut by the bowl where it wasn't properly located.
Date: 05/31/2012
Views: 3832
|
|
|
IMG_3384em
Remove the Billet pump from the circuit. Run with only electric pump. Input line connected directly to the regulator. At the same time, remove airbox pressure from differential gauge to get absolute fuel pressure out of regulator.
Date: 07/09/2012
Views: 4563
|
|
|
IMG_1339
Added a 12v power outlet to the instrument panel for charging iPhone or iPad (EFB)
Date: 04/26/2011
Views: 2669
|
|
|
IMG_0084post
Date: 09/02/2010
Views: 2902
|
|
|
IMG_0254post
Date: 09/14/2010
Views: 2798
|
|
|
IMG_0148post
Date: 09/04/2010
Views: 3147
|
|
|
IMG_1461p
Starboard wing outer flap bracket
Date: 06/05/2011
Views: 3279
|
|
|
IMG_1304
Inside fitting
Date: 04/14/2011
Views: 3226
|
|
|
IMG_3278
And the float bowl back in place, with no gasket sticking out anywhere. Then it was torqued down and safety wired. Both drip trays were then re-installed. Lastly, I ran the electric fuel pump for several minutes (at 6 PSI according to the gage) and che
Date: 05/30/2012
Views: 3952
|
|
|
IMG_1418ann
I had also been working on a stainless steel cover/mount which attaches to the lower firewall and will support the front edge of the monowheel hole cover.
Date: 12/20/2010
Views: 3353
|
|
|
IMG_2604
Got out the inspection mirror and made sure the gasket was in place all the way round the bowl. It was.
Date: 05/30/2012
Views: 5293
|
|
|
IMG_0191ann
Date: 09/08/2010
Views: 2574
|
|
|
IMG_0160post
Date: 09/05/2010
Views: 2889
|
|
|
New MC-4A 11
Because the sides are narrower and closer to the ends of the MC-4A's the old outer spacers no longer fit and it would be impossible to further shorten them, they have been replaced with a couple washers.
Date: 04/15/2012
Views: 5870
|
|
|
IMG_1496p
Rudder
Date: 06/18/2011
Views: 2923
|
|
|
IMG_1537ann
Did move on to the cover for the old gear well. Getting a decent but not perfect fit. Will continue to work on it.
Date: 06/19/2011
Views: 3026
|
|
|
IMG_1485s
Other side
Date: 06/10/2011
Views: 3033
|
|
|
IMG_0001post
Date: 07/12/2010
Views: 20944
|
|