|
IMG_1449p
Greatly simplified fuel plumbing, all cleaned up and tied down. Not a particularly good pic. I'll see if I can get a better one.
Date: 06/04/2011
Views: 2711
|
|
|
IMG_0456ann
2010 10 18 Mounted the new brake master cylinder with clecos to establish the location and size of the hole in the console needed for the brake levers.
Date: 10/18/2010
Views: 2961
|
|
|
IMG_2601
I took the float bowl off the starboard carb and removed the old gasket. The instructions with the new nitrile gasket said to apply some grease to hold the gasket in place while the bowl was replaced. I didn't have any grease but I had some light oil wh
Date: 05/30/2012
Views: 3160
|
|
|
IMG_1537ann
Did move on to the cover for the old gear well. Getting a decent but not perfect fit. Will continue to work on it.
Date: 06/19/2011
Views: 2978
|
|
|
IMG_0200post
Date: 09/08/2010
Views: 2807
|
|
|
IMG_0160post
Date: 09/05/2010
Views: 2838
|
|
|
IMG_0093post
Date: 09/03/2010
Views: 2919
|
|
|
IMG_1368
I ordered new registration numbers as the old numbers were not properly legal. They arrived and I put the starboard side on first.
Date: 05/18/2011
Views: 2992
|
|
|
IMG_0109post
Date: 09/03/2010
Views: 2729
|
|
|
IMG_1272ann
The nose wheel pant has been cut and prepared to receive inside layups to create a mounting flange.
Date: 03/28/2011
Views: 2710
|
|
|
IMG_0120post
Date: 09/03/2010
Views: 2829
|
|
|
IMG_0924ann
Seems like these are the correct holes for the new Riv-Nuts. I hope so anyway.
Date: 03/02/2011
Views: 4394
|
|
|
IMG_0199post
Date: 09/08/2010
Views: 2727
|
|
|
IMG_0102post
Date: 09/03/2010
Views: 2725
|
|
|
IMG_3540em
While the airbox was off, I again check all the pressure hoses to the carbs. Oh, what have we here. BIG leaks in the pressure lines to the carb bowls. Two leaks like this. Not observed before because the fittings were tied to that fuel line and the sp
Date: 07/30/2012
Views: 6106
|
|
|
IMG_0092post
Date: 09/03/2010
Views: 3001
|
|
|
IMG_1345ann
Used a big AN970 washer with an elastic stop nut to hold it all in place.
Date: 11/05/2010
Views: 3003
|
|
|
IMG_3290post
Here you can see where the gasket was cut by the bowl where it wasn't properly located.
Date: 05/31/2012
Views: 3755
|
|
|
IMG_1287ann
The console cover cut out. Now I have to figure out how to make the cuts for the slots for the brake levers and parking brake. Later there will be cutouts for the flap and trim switches as well as the brake reservoir.
Date: 03/30/2011
Views: 3467
|
|
|
Wings on 2
Went pretty well with three folks working on it.
Date: 07/01/2011
Views: 3138
|
|