|
IMG_1275ann
2011 03 29 Weather has turned cold again. No hanger work for a few days. Working in the shop on the wheel pants. The nose gear pant with mounting flange for the front piece
Date: 03/29/2011
Views: 3275
|
|
|
IMG_3327em
Next request was for a compression check. 80/80, 80/80, 80/80, 79/80. No problem there. But while doing this I decided to check the plugs. Cylinder #3 plugs looked different. WHY?
Date: 06/12/2012
Views: 4479
|
|
|
IMG_0151post
Date: 09/04/2010
Views: 2890
|
|
|
IMG_1535ann
This one isn't even close. I have no idea what went wrong. Maybe was bumped before drilled? Anyway, new brackets, along with other part which didn't make it into the parts box are on order from Bud. Kind of puts things on hold for a couple days.
Date: 06/19/2011
Views: 3062
|
|
|
IMG_0143post
Date: 09/04/2010
Views: 2717
|
|
|
IMG_0767ann
2010 11 23 Began putting the baffle/supports back on.
Date: 11/23/2010
Views: 3911
|
|
|
IMG_1241ann
2011 03 25 Test fit of the wheel pant mounting bracket. (2nd try, BTW) This one is OK.
Date: 03/25/2011
Views: 2941
|
|
|
IMG_1426ann
2010 12 21 - Taking advantage of a couple days of nice weather. Installed the cooling duct and heat exchangers.
Date: 12/21/2010
Views: 3232
|
|
|
IMG_0127post
Date: 09/03/2010
Views: 2684
|
|
|
2_snaps
The snap bases pulled off the screws first time the seat back was removed.
Date: 06/23/2011
Views: 2979
|
|
|
IMG_3538em
I removed the entire airbox to to check all the plumbing connections.
Date: 07/30/2012
Views: 5801
|
|
|
IMG_0031post
Date: 08/30/2010
Views: 3369
|
|
|
IMG_2692
The longest AN3-30 bolt I had was too short so a longer bolt is on order as are aluminum spacers to maintain proper alignment of the ends of the MCs.
Date: 04/09/2012
Views: 3202
|
|
|
IMG_0003ann
Date: 08/30/2010
Views: 5852
|
|
|
IMG_1400
Noticed that the underside of the starboard wing tip was scuffed. Applied filler to begin to clean it up. As well as continuing to work on pants and fairings.
Date: 05/26/2011
Views: 3250
|
|
|
IMG_1475p
Getting close to having wheel pants and gear leg fairings fitted
Date: 06/08/2011
Views: 3144
|
|
|
IMG_1589ann
I need to get two brake lines and a reservoir line in there and attached somehow.
Date: 03/15/2011
Views: 3366
|
|
|
New MC-4A 04
The MC-4A's must fit within this length and that 3/4" should allow the fit.
Date: 04/15/2012
Views: 3266
|
|
|
IMG_0160post
Date: 09/05/2010
Views: 2883
|
|
|
IMG_0219post
Date: 09/09/2010
Views: 2538
|
|