|
DSCN6112Ann
Date: 06/13/2007
Views: 3208
|
|
|
IMG_7530ann
First try was just to bolt the BSPP banjo onto the brake. Needless to say, that was just too simple to work. It wouldn't seat properly in the BSPT brake.
Date: 04/18/2010
Views: 3312
|
|
|
IMG_7268post
Date: 02/21/2010
Views: 4036
|
|
|
IMG_6789post
Width of the cross I-beam
Date: 12/10/2009
Views: 3873
|
|
|
Intercooler01
Date: 01/07/2006
Views: 3727
|
|
|
IMG_1236ann
The new pump is rated at 50 psi output.
Date: 06/21/2010
Views: 3814
|
|
|
4_snaps
Here is a picture of the original snap bases still on the passenger head rest along with one of the new screw snap bases.
Date: 06/23/2011
Views: 4520
|
|
|
DSCN6105Ann
Date: 06/13/2007
Views: 3750
|
|
|
LongRangeTankBits
Date: 07/31/2004
Views: 4816
|
|
|
Plexi02small
Date: 04/04/2005
Views: 5421
|
|
|
IMG_7266Crop
Date: 02/21/2010
Views: 4258
|
|
|
IMG_6972post
Pointing out areas relieved for fit over swing arm
Date: 12/27/2009
Views: 3196
|
|
|
IMG_1167ann
Went to the hanger after work and put the brake back together. Seems to work fine. I have not safety wired it yet as I want to add fluid, bleed and give it a good test beforehand. When all tests wel,l with no leaks, I'll wire it up. Could have used a
Date: 04/19/2010
Views: 3273
|
|
|
IMG_9570ann
2010 06 12 - Completed the plumbing for the new mechanical fuel pump this morning. Fire shield on all fuel lines. Everything connected in the proper sequence.
Date: 06/12/2010
Views: 3657
|
|
|
IMG_6694Ann
Date: 02/15/2008
Views: 3622
|
|
|
DSCN4668small
Date: 08/27/2006
Views: 3580
|
|
|
IMG_7539ann
Realizing that I'd need to do any remaining work at home, I removed the disk brake, gathered up the bits and headed for the shop. This is just a pic of the BSPT threaded hole in the disk brake. Had to clean it out as it was full of crap. Testing showed
Date: 04/18/2010
Views: 3156
|
|
|
LongRangeTankfront
Date: 07/31/2004
Views: 4120
|
|
|
OregonAero02small
Date: 09/28/2005
Views: 3086
|
|
|
DSCN6096Ann
Date: 06/12/2007
Views: 3643
|
|