|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 13014
|
|
|
IMG_0231
Date: 01/31/2014
Views: 10022
|
|
|
DSC00163
Rudder opened up to accept the push rod bracket. Alas no blue foam as it is the NG model. No instructions on how to proceed. Advice from Europa is to bod in some blue foam is it is not load bearing and is just a bed for the composite.
Date: 09/04/2015
Views: 10609
|
|
|
GoPro1 002
Garden before
Date: 03/17/2014
Views: 13618
|
|
|
IMG_0409
Date: 04/17/2015
Views: 8826
|
|
|
IMG_0230
Date: 01/31/2014
Views: 9455
|
|
|
IMG_0392
Date: 04/10/2015
Views: 8549
|
|
|
DSC00160
Foam removed from rear bulk head ready for plywood inserts
Date: 09/03/2015
Views: 10169
|
|
|
IMG_0340[1]
cloth cabinet installed.
Date: 09/04/2014
Views: 14269
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 8836
|
|
|
DSC00149
Winch installed in garage
Date: 09/01/2015
Views: 10676
|
|
|
IMG_0191[1]
Date: 09/12/2015
Views: 9159
|
|
|
IMG_0279
Insulation going in
Date: 04/02/2014
Views: 10832
|
|
|
IMG_0417
Date: 04/22/2015
Views: 9446
|
|
|
IMG_0229
At Steve's workshop packing the kit ready for transportation
Date: 01/31/2014
Views: 9471
|
|
|
DSC00229
Still some work to do but happy so far.
Date: 09/10/2015
Views: 13120
|
|
|
IMG_0391
Date: 04/10/2015
Views: 8872
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 7863
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 8578
|
|
|
Torque tube
Took some measurements and sent query to Europa. Response was I required the issue 1 TP38s
Date: 09/03/2015
Views: 5735
|
|