|
nex_2014_01_12_05
Port side top.
Date: 01/13/2014
Views: 6661
|
|
|
dsc09048
Template for the Stbd side. Note, you are not required per the manual to hook over the plywood with bid.
Date: 01/24/2013
Views: 7620
|
|
|
p1000632
p1000632.jpg
Date: 02/14/2012
Views: 8021
|
|
|
dsc08636
Here is Bill placing in some 2x6's to act as a support for the rear rib. The I-beam is 3 inches wide so the 2x6 fit perfectly. I'll explain later how those come into play.
Date: 04/15/2012
Views: 6882
|
|
|
p1000630
p1000630.jpg
Date: 02/14/2012
Views: 6979
|
|
|
dsc09070
While the layups are curing we stared work on the axles. Had to ream out the holes forMG02.
Date: 01/25/2013
Views: 7716
|
|
|
Wanted to make a copy of B16 to make the cuts on before I cut the actual B16 part.
Wanted to make a copy of B16 to make the cuts on before I cut the actual B16 part.
Date: 04/03/2016
Views: 13570
|
|
|
dsc09035
Rib one after cure of 420 and peel ply removed. Think we used 112g of 420 here due to the odd angle.
Date: 01/23/2013
Views: 7172
|
|
|
p1000705
p1000705.jpg
Date: 03/12/2012
Views: 5776
|
|
|
dsc08611
Unused Mono wheel components. I'll probably be selling these soon.
Date: 04/10/2012
Views: 12355
|
|
|
dsc09062
Bill applying peel ply!
Date: 01/24/2013
Views: 7761
|
|
|
p1000694
p1000694.jpg
Date: 03/12/2012
Views: 6447
|
|
|
p1000692
p1000692.jpg
Date: 03/12/2012
Views: 5764
|
|
|
dsc09020
Bill helping by putting a good key on the sockets.
Date: 01/22/2013
Views: 7451
|
|
|
p1000714
p1000714.jpg
Date: 03/12/2012
Views: 6171
|
|
|
dsc08600
Thinking of modifying the mono wheel trailer as a jig to perform the tri-gear conversion.
Date: 04/10/2012
Views: 13061
|
|
|
p1000689
p1000689.jpg
Date: 03/12/2012
Views: 6621
|
|
|
dsc09055
Wetting out stbd side.
Date: 01/24/2013
Views: 7477
|
|
|
nex_2013_08_24_01
Stb. side ribs 3 and 4 epibond in place with the 3 layups on all sides. At this point I was getting faster at doing layups however I only did one side at a time.
Date: 08/25/2013
Views: 6961
|
|
|
dsc08603
Since I'm going to have to remove the mono wheel I dont have much of an edge to close in the big hole in the bottom. I'll have a better look at it once its a tri-gear.
Date: 04/10/2012
Views: 10659
|
|