|
IMG_0410
Date: 04/17/2015
Views: 11338
|
|
|
Ipad 041
Shed Under construction
Date: 03/27/2014
Views: 9462
|
|
|
IMG_0400
Date: 04/14/2015
Views: 9888
|
|
|
IMG_0344[1]
Aircraft parts & Documents stored
Date: 09/04/2014
Views: 10530
|
|
|
IMG_0228
Andy & I having a good breakfast prior to the start of our trip to South Wales
Date: 01/31/2014
Views: 10679
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 9379
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 14409
|
|
|
IMG_0392
Date: 04/10/2015
Views: 8905
|
|
|
IMG_0389
Rear Bulk head fixed and peel plyed
Date: 04/10/2015
Views: 8992
|
|
|
Ipad 044
Shed Complete
Date: 04/13/2014
Views: 9746
|
|
|
IMG_0414
Date: 04/18/2015
Views: 10951
|
|
|
IMG_0394
Date: 04/10/2015
Views: 9217
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 8279
|
|
|
IMG_0412
Date: 04/17/2015
Views: 9929
|
|
|
DSC00153
Lathe installed
Date: 09/01/2015
Views: 11290
|
|
|
IMG_0417
Date: 04/22/2015
Views: 9922
|
|
|
DSC00215
foam removed to make space for the rudder bracket
Date: 09/09/2015
Views: 10325
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 9693
|
|
|
IMG_0189[1]
Date: 04/13/2014
Views: 12894
|
|
|
GoPro1 002
Garden before
Date: 03/17/2014
Views: 14505
|
|