|
IMG_0189[1]
Date: 04/13/2014
Views: 12327
|
|
|
IMG_0230
Date: 01/31/2014
Views: 9547
|
|
|
IMG_0231
Date: 01/31/2014
Views: 10123
|
|
|
IMG_0394
Date: 04/10/2015
Views: 8891
|
|
|
IMG_0412
Date: 04/17/2015
Views: 9537
|
|
|
IMG_0235
Date: 02/01/2014
Views: 9563
|
|
|
IMG_0340[1]
cloth cabinet installed.
Date: 09/04/2014
Views: 14427
|
|
|
IMG_0408
Date: 04/17/2015
Views: 9121
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 8934
|
|
|
IMG_0821
Trial fitted the torque tube but it looks like the TP38 bearing is too short!
Date: 09/03/2015
Views: 7885
|
|
|
IMG_0390
Date: 04/10/2015
Views: 8786
|
|
|
IMG_0187.JPG (2)
Workshop kitted out. All done in 3 weeks!
Date: 04/13/2014
Views: 11295
|
|
|
DSC00215
foam removed to make space for the rudder bracket
Date: 09/09/2015
Views: 9664
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 13241
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 7953
|
|
|
Ipad 039
Concrete base for 20ft x 10ft shed
Date: 03/22/2014
Views: 8272
|
|
|
IMG_0187[1]
Started to fit fixtures and fittings
Date: 04/13/2014
Views: 12061
|
|
|
IMG_0392
Date: 04/10/2015
Views: 8633
|
|
|
IMG_0237
Fuselage in the truck
Date: 02/01/2014
Views: 9984
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 9016
|
|