|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 15398
|
|
|
IMG_0409
Date: 04/17/2015
Views: 9418
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 15412
|
|
|
IMG_0404
Date: 04/17/2015
Views: 10737
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 10310
|
|
|
IMG_0245
Wife not happy. Aircraft parts in the house!
Date: 02/01/2014
Views: 10503
|
|
|
IMG_0189[1]
Date: 04/13/2014
Views: 13431
|
|
|
IMG_0414
Date: 04/18/2015
Views: 11275
|
|
|
IMG_0231
Date: 01/31/2014
Views: 10882
|
|
|
IMG_0417
Date: 04/22/2015
Views: 10265
|
|
|
IMG_0237
Fuselage in the truck
Date: 02/01/2014
Views: 10777
|
|
|
DSC00160
Foam removed from rear bulk head ready for plywood inserts
Date: 09/03/2015
Views: 11846
|
|
|
DSC00149
Winch installed in garage
Date: 09/01/2015
Views: 11627
|
|
|
DSC00153
Lathe installed
Date: 09/01/2015
Views: 11738
|
|
|
DSC00158
Date: 09/03/2015
Views: 15388
|
|
|
DSC00229
Still some work to do but happy so far.
Date: 09/10/2015
Views: 15421
|
|
|
IMG_0191[1]
Date: 09/12/2015
Views: 10178
|
|
|
DSC00155
As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.
Date: 09/03/2015
Views: 8712
|
|
|
IMG_0344[1]
Aircraft parts & Documents stored
Date: 09/04/2014
Views: 10874
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 10331
|
|