|
DSC00219
bracket installed
Date: 09/09/2015
Views: 11568
|
|
|
IMG_0187.JPG (2)
Workshop kitted out. All done in 3 weeks!
Date: 04/13/2014
Views: 11724
|
|
|
IMG_0412
Date: 04/17/2015
Views: 9899
|
|
|
DSC00153
Lathe installed
Date: 09/01/2015
Views: 11257
|
|
|
IMG_0340[1]
cloth cabinet installed.
Date: 09/04/2014
Views: 15060
|
|
|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 14255
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 14288
|
|
|
IMG_0408
Date: 04/17/2015
Views: 9436
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 9301
|
|
|
DSC00158
Date: 09/03/2015
Views: 14186
|
|
|
IMG_0189[1]
Date: 04/13/2014
Views: 12853
|
|
|
DSC00155
As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.
Date: 09/03/2015
Views: 8377
|
|
|
IMG_0237
Fuselage in the truck
Date: 02/01/2014
Views: 10356
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 9625
|
|
|
IMG_0245
Wife not happy. Aircraft parts in the house!
Date: 02/01/2014
Views: 10127
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 8252
|
|
|
IMG_0235
Date: 02/01/2014
Views: 9858
|
|
|
IMG_0410
Date: 04/17/2015
Views: 11315
|
|
|
DSC00160
Foam removed from rear bulk head ready for plywood inserts
Date: 09/03/2015
Views: 11062
|
|
|
IMG_0414
Date: 04/18/2015
Views: 10927
|
|