|
dsc08635
Other view of the ribs.
Date: 04/15/2012
Views: 8351
|
|
|
dsc08399
Atempting to remove the mass ballance brace but to only find out later that it is bonded at the top.
Date: 03/25/2012
Views: 9543
|
|
|
dsc08620
Removal of the mono firewall.
Date: 04/14/2012
Views: 18026
|
|
|
dsc08662
The 10“ diameter from the pilot hole.
Date: 04/22/2012
Views: 13391
|
|
|
DSC08800
starboard side
Date: 06/05/2012
Views: 10503
|
|
|
20141102_161000
template for new firewall.
Date: 11/02/2014
Views: 17616
|
|
|
dsc09028
Here the axles are getting the green goop. I used car carnauba wax as a release agent. Worked well jut get it on there thick. We also wrapped the top of the sockets with glad wrap to keep contaminates off of it while we moved it around.
Date: 01/22/2013
Views: 9992
|
|
|
nex_2013_08_24_04
As you see here the port side is done with rib 3 and 4. I didn't have photos of doing the layups.
Date: 08/25/2013
Views: 8137
|
|
|
This is the printer part showing the parts in place.
This is the printer part showing the parts in place.
Date: 04/03/2016
Views: 13903
|
|
|
p1000714
p1000714.jpg
Date: 03/12/2012
Views: 6638
|
|
|
nex_2013_08_24_03
nex_2013_08_24_03.jpg
Date: 08/25/2013
Views: 7825
|
|
|
dsc09041
Port side guides being placed for layup.
Date: 01/23/2013
Views: 9410
|
|
|
dsc08963
Port side. LG socket fitting.
Date: 10/01/2012
Views: 10575
|
|
|
p1000689
p1000689.jpg
Date: 03/12/2012
Views: 7049
|
|
|
nex_2013_08_24_06
Time for some clean up.
Date: 08/25/2013
Views: 8218
|
|
|
p1000691
p1000691.jpg
Date: 03/12/2012
Views: 6281
|
|
|
p1000697
p1000697.jpg
Date: 03/12/2012
Views: 7130
|
|
|
nex_2013_08_24_02
nex_2013_08_24_02.jpg
Date: 08/25/2013
Views: 7956
|
|
|
p1000730
p1000730.jpg
Date: 03/12/2012
Views: 6396
|
|
|
dsc09018
Started to make the axle jig. Used a simple setup of first taking large flat blocks of wood and caulking it to the floor somewhere over FS70. Then that allows me to fix the aluminum angle with a single screw once in its final position.
Date: 01/10/2013
Views: 10571
|
|