|
IMG_0279
Insulation going in
Date: 04/02/2014
Views: 11786
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 9976
|
|
|
IMG_0821
Trial fitted the torque tube but it looks like the TP38 bearing is too short!
Date: 09/03/2015
Views: 8581
|
|
|
IMG_0187.JPG (2)
Workshop kitted out. All done in 3 weeks!
Date: 04/13/2014
Views: 12182
|
|
|
IMG_0412
Date: 04/17/2015
Views: 10272
|
|
|
DSC00149
Winch installed in garage
Date: 09/01/2015
Views: 11627
|
|
|
IMG_0230
Date: 01/31/2014
Views: 10219
|
|
|
IMG_0189[1]
Date: 04/13/2014
Views: 13432
|
|
|
IMG_0235
Date: 02/01/2014
Views: 10215
|
|
|
DSC00160
Foam removed from rear bulk head ready for plywood inserts
Date: 09/03/2015
Views: 11855
|
|
|
IMG_0409
Date: 04/17/2015
Views: 9420
|
|
|
DSC00219
bracket installed
Date: 09/09/2015
Views: 12471
|
|
|
DSC00163
Rudder opened up to accept the push rod bracket. Alas no blue foam as it is the NG model. No instructions on how to proceed. Advice from Europa is to bod in some blue foam is it is not load bearing and is just a bed for the composite.
Date: 09/04/2015
Views: 12581
|
|
|
DSC00155
As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.
Date: 09/03/2015
Views: 8715
|
|
|
IMG_0229
At Steve's workshop packing the kit ready for transportation
Date: 01/31/2014
Views: 10307
|
|
|
IMG_0187[1]
Started to fit fixtures and fittings
Date: 04/13/2014
Views: 13099
|
|
|
IMG_0390
Date: 04/10/2015
Views: 9328
|
|
|
IMG_0228
Andy & I having a good breakfast prior to the start of our trip to South Wales
Date: 01/31/2014
Views: 11025
|
|
|
IMG_0245
Wife not happy. Aircraft parts in the house!
Date: 02/01/2014
Views: 10503
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 10340
|
|