|
IntercoolerFig3
Date: 01/07/2006
Views: 4453
|
|
|
DSCN6115Ann
Date: 06/14/2007
Views: 3774
|
|
|
IMG_6701Ann
Date: 02/15/2008
Views: 3635
|
|
|
IMG_0037
More retraction tests. Closer, but still won't quite go into up lock. Maybe 1/4" (0.635 cm) from engaging. Back under for a couple more hours before I finally see where the blue from the fitting is rubbing on the side of the tunnel where the seat
Date: 07/07/2010
Views: 3393
|
|
|
DSCN6122Ann
Date: 06/14/2007
Views: 3238
|
|
|
LongRangeTank
Date: 07/31/2004
Views: 4923
|
|
|
IMG_6782small
Date: 02/23/2008
Views: 3235
|
|
|
IMG_6973post
Pointing out areas relieved for fit over swing arm
Date: 12/27/2009
Views: 3299
|
|
|
LongRangeTankStbd
Date: 07/31/2004
Views: 4259
|
|
|
IMG_7429post
Here's a closeup of the hose end, bolt and washers. The hose end connector is identical to that which was on the master cylinder end so this should easily replace the 90 degree AN hose end provided. We'll know better later this week when I can get to th
Date: 03/15/2010
Views: 3016
|
|
|
DSCN6116Ann
Date: 06/14/2007
Views: 3228
|
|
|
IMG_6790post
Height of the cross I-beam
Date: 12/10/2009
Views: 3504
|
|
|
IMG_7432post
The fuel pump is supposed to be capable of 100 GPH @ 50 PSI. The fuel pressure regulator will drop that to 10 PSI for the existing Rotax fuel pressure regulator.
Date: 03/15/2010
Views: 3643
|
|
|
IMG_7380ann
This pic is a closeup of the starboard side of the master cylinder. The red thing is the screw cap covering the brake fluid reservoir.
Date: 03/07/2010
Views: 3486
|
|
|
IMG_7268post
Date: 02/21/2010
Views: 3991
|
|
|
IMG_6792post
Width and thickness of the tail wheel "U" channel
Date: 12/10/2009
Views: 3371
|
|
|
IMG_7529ann
The new BSPP (British Standard Pipe Parallel) banjo bolts finally arrived from Speed Flow of Australia last week. Due to a death in the family and illnesses, I haven't gotten back to working on the Europa for several weeks. But I did today. I had also
Date: 04/18/2010
Views: 3126
|
|
|
IMG_6789post
Width of the cross I-beam
Date: 12/10/2009
Views: 3831
|
|
|
1_snaps
The snap bases for the seat back cushions were poorly installed by my interior guy. Just a skinny screw through the over-sized hole the snap base where the original rivet went.
Date: 06/23/2011
Views: 4665
|
|
|
IMG_0036
2010 07 07 - Back to retraction tests. Thought that the fixtures sticking up off the caliper might be a problem. Replaced them with the 90 degree fitting and a straight hose end. Much neater and more compact, but I'll have to bleed the brakes again whe
Date: 07/07/2010
Views: 3867
|
|