|
IMGA0589
Date: 03/29/2013
Views: 10878
|
|
|
IMGA0800
all that work then you have to cut a big chunk out!!
Date: 05/13/2013
Views: 7330
|
|
|
IMGA0811
Flap closeout
Date: 05/14/2013
Views: 9198
|
|
|
IMGA0820
Aileron closeout
Date: 05/15/2013
Views: 9223
|
|
|
IMGA0585
Date: 03/18/2013
Views: 10360
|
|
|
IMGA0581
Date: 03/18/2013
Views: 10021
|
|
|
IMGA0756
Some dry micro to stick the block to the spar
Date: 05/05/2013
Views: 6749
|
|
|
IMGA0833
Remove trailing edge support ready for skin lay up
Date: 05/17/2013
Views: 8494
|
|
|
IMGA1259
Not bad looking for a classic wing if i do say so myself. Had to make a wing dolly for easier manoeuvrability round the shop.
Date: 09/23/2013
Views: 20102
|
|
|
IMGA0624
Date: 04/11/2013
Views: 8115
|
|
|
IMGA0641
EXOTHERM!! My worst moment yet
Date: 04/16/2013
Views: 7244
|
|
|
IMGA0661
Screws through ribs to align blocks.....must remember to remove them before the lay up
Date: 04/17/2013
Views: 6437
|
|
|
IMGA0623
Date: 04/09/2013
Views: 8204
|
|
|
IMGA0664
Scrap bit of foam which will get sanded to match the profile of the block. It takes up the gap between spar and end of the block
Date: 04/17/2013
Views: 7109
|
|
|
IMGA0572
Date: 03/17/2013
Views: 8753
|
|
|
IMGA0716
Cracked off the jig, flipped over, and there we go iv got half a wing!!
Date: 04/23/2013
Views: 6857
|
|
|
IMGA0680
These are the rear blocks where the bell cranks sit in. Note the vent holes
Date: 04/18/2013
Views: 6912
|
|
|
IMGA0732
The other rear blocks, laying up the ribs and including the mounting plates for the flap hinges.
Date: 04/25/2013
Views: 6818
|
|
|
IMGA0657
After repair
Date: 04/17/2013
Views: 7412
|
|
|
IMGA0701
First wings L.E layed up and peel plyed. The blue foam is keeping in place a 90 degree strip which is keeping the end of the uni cloth bent under to aid bonding to the rear of the spar. A helpful tip from Mike Gregory.......Oh wanted to say it took 8 and
Date: 04/20/2013
Views: 7088
|
|