|
20141102_162118
Cut it out.
Date: 11/02/2014
Views: 68049
|
|
|
dsc08617
After removing the green tape.
Date: 04/14/2012
Views: 66421
|
|
|
dsc08623
bungee cord removal.
Date: 04/14/2012
Views: 17606
|
|
|
20141102_153539
Out. Ad you can see the screw is sill in the nut plate. it came out later.
Date: 11/02/2014
Views: 17235
|
|
|
dsc08621
Removal of the brake master for the mono.
Date: 04/14/2012
Views: 17110
|
|
|
dsc08622
Removed.
Date: 04/14/2012
Views: 16718
|
|
|
20141102_154504
Cut old fuel lines. Gona have to replace them anyways. Now I just need to remove the stop block where the gear handle went.
Date: 11/02/2014
Views: 16682
|
|
|
20141102_154450
Gear cover removed, now for removing the throttle box. This is all prep work to patch up the mono wheel hole.
Date: 11/02/2014
Views: 16645
|
|
|
dsc08620
Removal of the mono firewall.
Date: 04/14/2012
Views: 16044
|
|
|
20141102_161000
template for new firewall.
Date: 11/02/2014
Views: 15646
|
|
|
dsc08619
Roap tied to the engine mount frame to hoist the airframe.
Date: 04/14/2012
Views: 15554
|
|
|
dsc08618
Block and tackle used to hoist the front of the aircraft to aid in creating a jig. This hoist reduces the weight to 25%.
Date: 04/14/2012
Views: 15162
|
|
|
photo
No pictures of the progress of putting in the LG layups on the port side. Here I am putting down the peel ply.
Date: 08/20/2012
Views: 14927
|
|
|
20141102_161036
Everything looking good.
Date: 11/02/2014
Views: 14859
|
|
|
20141102_161049
20141102_161049.jpg
Date: 11/02/2014
Views: 14045
|
|
|
dsc08664
The gell coat really gums up the sand paper. Still a bit more to remove.
Date: 04/22/2012
Views: 13231
|
|
|
photo (2)
Small area to work in. Back was killing me after that job. can't wait to give my back the same treatment when doing the ribs and starboard side.
Date: 08/20/2012
Views: 13134
|
|
|
photo (1)
Bad pic, but shows the end of the reinforcement layups (port side).
Date: 08/20/2012
Views: 12317
|
|
|
dsc08662
The 10“ diameter from the pilot hole.
Date: 04/22/2012
Views: 12279
|
|
|
dsc08661
Locating the center of the main gear hole. Used a pilot to be used to measure out the 10“ diameter on the bottom.
Date: 04/22/2012
Views: 11702
|
|