|
IMG_0189[1]
Date: 04/13/2014
Views: 12203
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 8853
|
|
|
DSC00163
Rudder opened up to accept the push rod bracket. Alas no blue foam as it is the NG model. No instructions on how to proceed. Advice from Europa is to bod in some blue foam is it is not load bearing and is just a bed for the composite.
Date: 09/04/2015
Views: 10630
|
|
|
DSC00153
Lathe installed
Date: 09/01/2015
Views: 10755
|
|
|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 13038
|
|
|
DSC00160
Foam removed from rear bulk head ready for plywood inserts
Date: 09/03/2015
Views: 10188
|
|
|
IMG_0400
Date: 04/14/2015
Views: 9432
|
|
|
IMG_0187[1]
Started to fit fixtures and fittings
Date: 04/13/2014
Views: 11941
|
|
|
Ipad 039
Concrete base for 20ft x 10ft shed
Date: 03/22/2014
Views: 8192
|
|
|
IMG_0191[1]
Date: 09/12/2015
Views: 9172
|
|
|
IMG_0245
Wife not happy. Aircraft parts in the house!
Date: 02/01/2014
Views: 9740
|
|
|
IMG_0187.JPG (2)
Workshop kitted out. All done in 3 weeks!
Date: 04/13/2014
Views: 11187
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 8593
|
|
|
DSC00215
foam removed to make space for the rudder bracket
Date: 09/09/2015
Views: 9500
|
|
|
IMG_0230
Date: 01/31/2014
Views: 9471
|
|
|
IMG_0279
Insulation going in
Date: 04/02/2014
Views: 10849
|
|
|
IMG_0392
Date: 04/10/2015
Views: 8559
|
|
|
IMG_0344[1]
Aircraft parts & Documents stored
Date: 09/04/2014
Views: 10146
|
|
|
IMG_0235
Date: 02/01/2014
Views: 9497
|
|
|
IMG_0414
Date: 04/18/2015
Views: 10511
|
|