|
dsc09072
Here is a shot of the working angle. This was so much better than leaning over the edge. Kim's idea. Notice the heater behind Kim, this was key to keeping the temps even though the temps outside were in the 40's.
Date: 01/26/2013
Views: 8678
|
|
|
2012-08-18_19-58-15_689
Port side. Red highlighted area shows area with little reinforcement on inside. This is before I did the belly layup per the manual.
Date: 08/19/2012
Views: 11109
|
|
|
dsc08626
Put in a 2x4 in the main wing spar tunnel and located the pins. This was only used to aid in keeping the plane from tipping.
Date: 04/14/2012
Views: 11675
|
|
|
20160403_160502.jpg
20160403_160502.jpg
Date: 04/03/2016
Views: 13211
|
|
|
dsc09040
The gap from the bottom of the socket and the belly is as you see. The only way to get it all the way down was to lower the belly to 15" which was not considered an option. Belly hight is 16.0" with the axle width at 82.50" and axle cent
Date: 01/23/2013
Views: 9505
|
|
|
nex_2014_01_12_05
Port side top.
Date: 01/13/2014
Views: 7401
|
|
|
p1000634
p1000634.jpg
Date: 02/14/2012
Views: 6845
|
|
|
dsc08622
Removed.
Date: 04/14/2012
Views: 17401
|
|
|
photo (1)
Bad pic, but shows the end of the reinforcement layups (port side).
Date: 08/20/2012
Views: 12682
|
|
|
p1000701
p1000701.jpg
Date: 03/12/2012
Views: 6243
|
|
|
dsc08607
Starting to prep the bays for the tri-gear conversion.
Date: 04/10/2012
Views: 9863
|
|
|
dsc08637
The mono wheel has been removed. Sad to see never used parts coming off the plane.
Date: 04/15/2012
Views: 7644
|
|
|
dsc08613
Unused Mono wheel components. I'll probably be selling these soon.
Date: 04/10/2012
Views: 10865
|
|
|
dsc08967
Little clean up required on Port side.
Date: 10/01/2012
Views: 10009
|
|
|
dsc09075
Stbd side after cure. We died the uni in with rib 1.
Date: 01/26/2013
Views: 8744
|
|
|
dsc08606
Old mass balance arm.
Date: 04/10/2012
Views: 9830
|
|
|
dsc09064
Bill does nice peel ply work!
Date: 01/24/2013
Views: 8508
|
|
|
dsc08610
Whats missing?
Date: 04/10/2012
Views: 8716
|
|
|
20141102_154504
Cut old fuel lines. Gona have to replace them anyways. Now I just need to remove the stop block where the gear handle went.
Date: 11/02/2014
Views: 17309
|
|
|
p1000721
p1000721.jpg
Date: 03/12/2012
Views: 7010
|
|