|
IMG_0191[1]
Date: 09/12/2015
Views: 9398
|
|
|
DSC00155
As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.
Date: 09/03/2015
Views: 8170
|
|
|
DSC00160
Foam removed from rear bulk head ready for plywood inserts
Date: 09/03/2015
Views: 10565
|
|
|
DSC00214
blue foam placed in rudder to fill void
Date: 09/08/2015
Views: 10857
|
|
|
IMG_0230
Date: 01/31/2014
Views: 9663
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 8051
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 13578
|
|
|
IMG_0389
Rear Bulk head fixed and peel plyed
Date: 04/10/2015
Views: 8818
|
|
|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 13543
|
|
|
IMG_0390
Date: 04/10/2015
Views: 8883
|
|
|
Torque tube
Took some measurements and sent query to Europa. Response was I required the issue 1 TP38s
Date: 09/03/2015
Views: 5896
|
|
|
IMG_0187[1]
Started to fit fixtures and fittings
Date: 04/13/2014
Views: 12238
|
|
|
IMG_0251
Kit safely in Storage.
Date: 02/01/2014
Views: 9602
|
|
|
DSC00149
Winch installed in garage
Date: 09/01/2015
Views: 10902
|
|
|
IMG_0189[1]
Date: 04/13/2014
Views: 12516
|
|
|
IMG_0187.JPG (2)
Workshop kitted out. All done in 3 weeks!
Date: 04/13/2014
Views: 11451
|
|
|
DSC00158
Date: 09/03/2015
Views: 13503
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 8895
|
|
|
IMG_0231
Date: 01/31/2014
Views: 10229
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 9095
|
|