|
IMG_7540ann
That leaves two choices: #1 - tap the brake in BSPP threads or #2 - run the BSPT die over the bolt to thread in BSPT. The brake being aluminum and the bolt being stainless steel, I decided to go with #1 as it seemed easier.
Date: 04/18/2010
Views: 3046
|
|
|
EuropaCheckListBack
Date: 12/06/2008
Views: 3700
|
|
|
IMG_2861Ann
Date: 12/06/2008
Views: 3394
|
|
|
Airmaster00small
Date: 09/29/2005
Views: 3761
|
|
|
P4141325
Date: 04/16/2006
Views: 3854
|
|
|
DSCN6127Ann
Date: 06/14/2007
Views: 3081
|
|
|
DSCN6108Ann
Date: 06/13/2007
Views: 3367
|
|
|
IMG_9571post
The fuel lines were tied with tie-wraps and 1/2" (12.7 mm) rubber fuel hose lengths. The vent hose was tied in as well by running it through short lengths of fuel hose and using tie-wraps to hold the rubber hose and protect the vent line from chafin
Date: 06/12/2010
Views: 4349
|
|
|
IMG_6975post
Overall length of ramp
Date: 12/27/2009
Views: 3511
|
|
|
DSCN6110Ann
Date: 06/13/2007
Views: 3412
|
|
|
DSCN6101Ann
Date: 06/13/2007
Views: 3982
|
|
|
IMG_6782small
Date: 02/23/2008
Views: 3234
|
|
|
IMG_7387ann
This pic shows the port side of the master cylinder. The red knob is the parking brake. You squeeze the brake lever and turn the knob (top back toward you) and release the lever. This holds the brake on. To release the brake you simply squeeze the bra
Date: 03/07/2010
Views: 3488
|
|
|
IMG_6973post
Pointing out areas relieved for fit over swing arm
Date: 12/27/2009
Views: 3292
|
|
|
IMG_0036
2010 07 07 - Back to retraction tests. Thought that the fixtures sticking up off the caliper might be a problem. Replaced them with the 90 degree fitting and a straight hose end. Much neater and more compact, but I'll have to bleed the brakes again whe
Date: 07/07/2010
Views: 3856
|
|
|
IMG_7269post
Date: 02/21/2010
Views: 3478
|
|
|
DSCN6105Ann
Date: 06/13/2007
Views: 3682
|
|
|
1_Door_Knobs
The new door knob mounting hardware is a stainless steel "binding post" acquired from McMaster-Carr. These things are available in myriad materials and sizes. There just happened to be a perfect size in the stainless steel variety which I pref
Date: 06/23/2011
Views: 4538
|
|
|
IntercoolerFig3
Date: 01/07/2006
Views: 4447
|
|
|
IntercoolerFig2
Date: 01/07/2006
Views: 3455
|
|