|
IMGA0712
Made some stands and a reference plate which is at 90 degrees to the spar
Date: 04/23/2013
Views: 7829
|
|
|
IMGA0756
Some dry micro to stick the block to the spar
Date: 05/05/2013
Views: 6981
|
|
|
IMGA0722
Just testing out the rear blocks for an idea what it will look like
Date: 04/24/2013
Views: 7406
|
|
|
IMGA0623
Date: 04/09/2013
Views: 8438
|
|
|
IMGA0657
After repair
Date: 04/17/2013
Views: 7621
|
|
|
IMGA0878
Wing rib close outs
Date: 05/30/2013
Views: 8514
|
|
|
IMGA0660
You can see the wash out build into the block
Date: 04/17/2013
Views: 6994
|
|
|
IMGA0635
Rib ready for floxing
Date: 04/14/2013
Views: 7515
|
|
|
IMGA0737
The small bloke with two mounting plates at the outrigger position.
Date: 04/26/2013
Views: 7330
|
|
|
IMGA0572
Date: 03/17/2013
Views: 9020
|
|
|
IMGA1259
Not bad looking for a classic wing if i do say so myself. Had to make a wing dolly for easier manoeuvrability round the shop.
Date: 09/23/2013
Views: 20709
|
|
|
IMGA0770
Two are a time baby yeah!!!!!
Date: 05/10/2013
Views: 7536
|
|
|
IMGA0620
Date: 04/09/2013
Views: 8285
|
|
|
IMGA1057
And a few hours later.......
Date: 08/09/2013
Views: 7149
|
|
|
IMGA0573
Date: 03/17/2013
Views: 9971
|
|
|
IMGA0833
Remove trailing edge support ready for skin lay up
Date: 05/17/2013
Views: 8758
|
|
|
IMGA0634
Shimmed for correct washout
Date: 04/14/2013
Views: 7577
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 7433
|
|
|
IMGA0680
These are the rear blocks where the bell cranks sit in. Note the vent holes
Date: 04/18/2013
Views: 7133
|
|
|
IMGA0613
Date: 04/09/2013
Views: 11689
|
|