|
IMGA0707
The next day me and my helper Ang did the other wing. This time it only took 6 and half hours so left us time to trim the other wing
Date: 04/21/2013
Views: 7438
|
|
|
IMGA1057
And a few hours later.......
Date: 08/09/2013
Views: 7332
|
|
|
IMGA0785
One side done. A straight edge is bonded on to aid rigidity once some of the foam is cut away
Date: 05/12/2013
Views: 7953
|
|
|
IMGA0661
Screws through ribs to align blocks.....must remember to remove them before the lay up
Date: 04/17/2013
Views: 6847
|
|
|
IMGA0635
Rib ready for floxing
Date: 04/14/2013
Views: 7669
|
|
|
IMGA0641
EXOTHERM!! My worst moment yet
Date: 04/16/2013
Views: 7619
|
|
|
IMGA0712
Made some stands and a reference plate which is at 90 degrees to the spar
Date: 04/23/2013
Views: 8010
|
|
|
IMGA0878
Wing rib close outs
Date: 05/30/2013
Views: 8731
|
|
|
IMGA0571
Date: 03/17/2013
Views: 25719
|
|
|
IMGA0722
Just testing out the rear blocks for an idea what it will look like
Date: 04/24/2013
Views: 7566
|
|
|
IMGA0664
Scrap bit of foam which will get sanded to match the profile of the block. It takes up the gap between spar and end of the block
Date: 04/17/2013
Views: 7489
|
|
|
IMGA0657
After repair
Date: 04/17/2013
Views: 7774
|
|
|
IMGA1030
Wing tips prepped for shaping thanks to Tony K's web blog on his kit #272
Date: 08/08/2013
Views: 8208
|
|
|
IMGA0613
Date: 04/09/2013
Views: 11910
|
|
|
IMGA1259
Not bad looking for a classic wing if i do say so myself. Had to make a wing dolly for easier manoeuvrability round the shop.
Date: 09/23/2013
Views: 21131
|
|
|
IMGA0589
Date: 03/29/2013
Views: 11411
|
|
|
IMGA0573
Date: 03/17/2013
Views: 10184
|
|
|
IMGA0626
Hole ready for stall warner
Date: 04/11/2013
Views: 8123
|
|
|
IMGA0634
Shimmed for correct washout
Date: 04/14/2013
Views: 7754
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 7587
|
|