|
E1
[quote="Bud Yerly"]"Make a glass cover that fits the hole out of three sheets of bid laid up on a flat surface. After cure, hold it up to the bottom of the plane and mark the contour. Cut and approximate the fit. It should be near level
Date: 10/05/2012
Views: 11429
|
|
|
p1000724
p1000724.jpg
Date: 03/12/2012
Views: 7324
|
|
|
DSC08801
starboard side
Date: 06/05/2012
Views: 9400
|
|
|
p1000629
p1000629.jpg
Date: 02/14/2012
Views: 7669
|
|
|
p1000721
p1000721.jpg
Date: 03/12/2012
Views: 6915
|
|
|
dsc08399
Atempting to remove the mass ballance brace but to only find out later that it is bonded at the top.
Date: 03/25/2012
Views: 9223
|
|
|
dsc08623
bungee cord removal.
Date: 04/14/2012
Views: 17213
|
|
|
dsc09040
The gap from the bottom of the socket and the belly is as you see. The only way to get it all the way down was to lower the belly to 15" which was not considered an option. Belly hight is 16.0" with the axle width at 82.50" and axle cent
Date: 01/23/2013
Views: 9037
|
|
|
DSC08800
starboard side
Date: 06/05/2012
Views: 9412
|
|
|
p1000628
p1000628.jpg
Date: 02/14/2012
Views: 7562
|
|
|
dsc08633
We had to put the plane somewhat down near the trailer with the main up so that we could get the right contour for the ribs. Reminds me of a B-17 with the main just showing.
Date: 04/14/2012
Views: 7376
|
|
|
dsc08966
Port side LG socket hole.
Date: 10/01/2012
Views: 10348
|
|
|
dsc09061
Applying the layups on stbd side.
Date: 01/24/2013
Views: 7984
|
|
|
p1000693
p1000693.jpg
Date: 03/12/2012
Views: 6502
|
|
|
dsc08611
Unused Mono wheel components. I'll probably be selling these soon.
Date: 04/10/2012
Views: 12805
|
|
|
dsc08629
In a few mins she will no longer be a monowheel :-(
Date: 04/14/2012
Views: 7916
|
|
|
dsc09062
Bill applying peel ply!
Date: 01/24/2013
Views: 8116
|
|
|
nex_2014_01_12_07
Port side.
Date: 01/13/2014
Views: 7064
|
|
|
p1000722
p1000722.jpg
Date: 03/12/2012
Views: 6602
|
|
|
dsc08960
Stb side after layups and peel ply removed.
Date: 10/01/2012
Views: 11446
|
|