|
IMG_0032post
Date: 09/01/2010
Views: 3547
|
|
|
New MC-4A02
And it's too wide to fit in between the mounts. I have 1 1/4 x 1 1/4 x 1/8 Al angle on order to fix the width problem and I think I know how to fix the length problem as well. Then I can address the height issue...
Date: 04/11/2012
Views: 2899
|
|
|
IMG_0247post
Date: 09/13/2010
Views: 2500
|
|
|
New MC-4A 05
With the attach fitting fully screwed on to the end of the thread, the last bit of thread is just visible in the fitting.
Date: 04/12/2012
Views: 2805
|
|
|
IMG_0093post
Date: 09/03/2010
Views: 2897
|
|
|
IMG_0038post
Date: 09/01/2010
Views: 3652
|
|
|
IMG_1469p
Cleaned up the tunnel area.
Date: 06/05/2011
Views: 3011
|
|
|
4_snaps
Old snap base installation with the new snap base.
Date: 06/23/2011
Views: 2872
|
|
|
IMG_1578ann
2011 03 11 Installation of the parking brake valve completed and the brake lines attached. Hard to believe that took all day...
Date: 03/11/2011
Views: 2522
|
|
|
IMG_0107post
Date: 09/03/2010
Views: 2612
|
|
|
IMG_0233post
Date: 09/11/2010
Views: 3400
|
|
|
1_snaps
The headrest snap bases for the seat back tabs were never done well by my upholstery guy. Just a skinny screw through the hole where a big rivet had been removed. And simple nuts on the underside.
Date: 06/23/2011
Views: 2960
|
|
|
IMG_0127post
Date: 09/03/2010
Views: 2627
|
|
|
IMG_0266ann
2010 09 14 - The aircraft on the trailer at the hotel ready for an early morning departure. The brace on the rudder proved to be a negative and was removed at the first stop. The rudder was also removed and strapped to the trailer. Thanks to Tommy Meye
Date: 09/14/2010
Views: 2743
|
|
|
IMG_1370em
The port side went on just fine. Had to contact the vendor and arrange for a new X.
Date: 05/18/2011
Views: 2943
|
|
|
IMG_0164post
Date: 09/05/2010
Views: 3006
|
|
|
IMG_3331em
Turn the plugs over and one plug on #3 looks funny. Calls for a closer look...
Date: 06/12/2012
Views: 3551
|
|
|
IMG_3571em_r
Pulled all the pressure hose off again and check for leaks and continuity. All OK, no problems at all.
Date: 08/01/2012
Views: 5629
|
|
|
IMG_1461p
Starboard wing outer flap bracket
Date: 06/05/2011
Views: 3208
|
|
|
IMG_1471p
Removed the backing paper and carefully pressed the new X down. Then VERY carefully pulled the release paper off the front, ensuring the X was fully adhered.
Date: 06/07/2011
Views: 3068
|
|