|
dsc09021
BIG THANK YOU to my Uncle Kim Prout for flying out to help me with getting the gear legs set. He also helped me slow down and plan ahead. As an excited new builder its easy to get in a rush to try achieve something tangible. Im sure after that week of b
Date: 01/22/2013
Views: 9467
|
|
|
dsc08617
After removing the green tape.
Date: 04/14/2012
Views: 73338
|
|
|
p1000635
p1000635.jpg
Date: 02/14/2012
Views: 6909
|
|
|
dsc09045
Uncle Kim at work. We would tilt to starboard to work on the port side vice versa.
Date: 01/23/2013
Views: 10160
|
|
|
DSC08797
Port side
Date: 06/05/2012
Views: 10591
|
|
|
photo (1)
Bad pic, but shows the end of the reinforcement layups (port side).
Date: 08/20/2012
Views: 13301
|
|
|
20141102_154504
Cut old fuel lines. Gona have to replace them anyways. Now I just need to remove the stop block where the gear handle went.
Date: 11/02/2014
Views: 18710
|
|
|
dsc09036
Rib one port side again used around 112g of 420 cured at 78f for 12 hours.
Date: 01/23/2013
Views: 9095
|
|
|
dsc09064
Bill does nice peel ply work!
Date: 01/24/2013
Views: 9145
|
|
|
dsc08618
Block and tackle used to hoist the front of the aircraft to aid in creating a jig. This hoist reduces the weight to 25%.
Date: 04/14/2012
Views: 17125
|
|
|
p1000706
p1000706.jpg
Date: 03/12/2012
Views: 6193
|
|
|
dsc09057
Wetting out stbd side.
Date: 01/24/2013
Views: 8936
|
|
|
nex_2014_01_25_15
Doing mod 59.
Date: 01/25/2014
Views: 8024
|
|
|
nex_2013_08_24_06
Time for some clean up.
Date: 08/25/2013
Views: 8231
|
|
|
dsc08630
Though this was a neat pic of the mono wheel in the retracted position.
Date: 04/14/2012
Views: 8249
|
|
|
p1000723
p1000723.jpg
Date: 03/12/2012
Views: 6942
|
|
|
DSC08799
Port side
Date: 06/05/2012
Views: 10312
|
|
|
p1000637
p1000637.jpg
Date: 02/14/2012
Views: 6710
|
|
|
dsc09051
Mix it up Kim! FYI I hate this scale from aircraft spruce, it times out in one min if your plugged in or not. I would have to tap the scale while Kim mixed. We were using masks due to being in an enclosed area and I'm very allergic to the hardener (bumm
Date: 01/24/2013
Views: 9291
|
|
|
dsc08639
More of the same. I was going to cut the carpet and form it to the ribs and staple it in place but decided that was just a time vampire and pointless since the airframe is holding it in place.
Date: 04/15/2012
Views: 9021
|
|