|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 8860
|
|
|
IMG_0400
Date: 04/14/2015
Views: 9435
|
|
|
Torque tube
Took some measurements and sent query to Europa. Response was I required the issue 1 TP38s
Date: 09/03/2015
Views: 5742
|
|
|
DSC00155
As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.
Date: 09/03/2015
Views: 7996
|
|
|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 13047
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 8594
|
|
|
IMG_0389
Rear Bulk head fixed and peel plyed
Date: 04/10/2015
Views: 8652
|
|
|
DSC00163
Rudder opened up to accept the push rod bracket. Alas no blue foam as it is the NG model. No instructions on how to proceed. Advice from Europa is to bod in some blue foam is it is not load bearing and is just a bed for the composite.
Date: 09/04/2015
Views: 10637
|
|
|
IMG_0391
Date: 04/10/2015
Views: 8900
|
|
|
IMG_0187.JPG (2)
Workshop kitted out. All done in 3 weeks!
Date: 04/13/2014
Views: 11197
|
|
|
IMG_0412
Date: 04/17/2015
Views: 9447
|
|
|
IMG_0392
Date: 04/10/2015
Views: 8568
|
|
|
Ipad 044
Shed Complete
Date: 04/13/2014
Views: 9276
|
|
|
Ipad 041
Shed Under construction
Date: 03/27/2014
Views: 9050
|
|
|
IMG_0409
Date: 04/17/2015
Views: 8849
|
|
|
DSC00158
Date: 09/03/2015
Views: 12989
|
|
|
IMG_0251
Kit safely in Storage.
Date: 02/01/2014
Views: 9401
|
|
|
DSC00229
Still some work to do but happy so far.
Date: 09/10/2015
Views: 13153
|
|
|
DSC00214
blue foam placed in rudder to fill void
Date: 09/08/2015
Views: 10482
|
|
|
DSC00149
Winch installed in garage
Date: 09/01/2015
Views: 10692
|
|