|
IMG_2861Ann
Date: 12/06/2008
Views: 3319
|
|
|
IMG_6967post
Starboard side juncture of main beam with cross beam.
Date: 12/27/2009
Views: 3007
|
|
|
IMG_6702Ann
Date: 02/15/2008
Views: 3701
|
|
|
IMG_7541ann
It took almost an hour to carefully and safely get the tap started in the aluminum brake. I sure didn't want to screw that up. Once I had a good start and the tap began to cut, I clamped the tap in the vice with the brake held high so chips fall out and
Date: 04/18/2010
Views: 2945
|
|
|
DSCN6106Ann
Date: 06/13/2007
Views: 3397
|
|
|
Condition Inspection P1 T
Date: 02/04/2010
Views: 3071
|
|
|
IMG_0920post
Some pics after the engine run-up and taxi tests today.
Date: 07/01/2010
Views: 4876
|
|
|
IMG_6792post
Width and thickness of the tail wheel "U" channel
Date: 12/10/2009
Views: 3258
|
|
|
2ndAlternator04small
Date: 04/04/2005
Views: 3735
|
|
|
LongRangeTankIns
Date: 07/31/2004
Views: 4323
|
|
|
DSCN6111Ann
Date: 06/13/2007
Views: 3278
|
|
|
MDO_Aircraft_P1
Date: 10/18/2009
Views: 6369
|
|
|
IMG_7429post
Here's a closeup of the hose end, bolt and washers. The hose end connector is identical to that which was on the master cylinder end so this should easily replace the 90 degree AN hose end provided. We'll know better later this week when I can get to th
Date: 03/15/2010
Views: 2900
|
|
|
Calliper 2
The best solution is shown in this pic from Mike Parkin. A Banjo fitting. The Banjo bolt is straight threads, it lies low, out of the way of grabby things and is stoutly attached. So, I have a number of bits on order from various suppliers in an attem
Date: 06/23/2009
Views: 3226
|
|
|
P4141326
Date: 04/16/2006
Views: 4042
|
|
|
IMG_9558ann
Gathered up the bits needed to install the new pump: spacer/gasket, studs, lock washers & nuts.
Date: 06/06/2010
Views: 3979
|
|
|
IntercoolerPg1
Date: 01/07/2006
Views: 3991
|
|
|
IMG_9562ann
2010 06 06 - Made up an adaptor that fits the bleed and doesn't leak. Began to run fluid into the system. Went up to the master cylinder/reservoir to check on progress. Was I getting bubbles through the bit of fluid it put in back on the 3rd?
Date: 06/06/2010
Views: 3023
|
|
|
DSCN6123Ann
Date: 06/14/2007
Views: 2975
|
|
|
IMG_6974post
Length of tire "well"
Date: 12/27/2009
Views: 3295
|
|