|
p1000617
p1000617.jpg
Date: 01/29/2012
Views: 10071
|
|
|
dsc09046
Making a layup schedule for rib 1.
Date: 01/23/2013
Views: 9320
|
|
|
20141102_154504
Cut old fuel lines. Gona have to replace them anyways. Now I just need to remove the stop block where the gear handle went.
Date: 11/02/2014
Views: 18678
|
|
|
p1000711
p1000711.jpg
Date: 03/12/2012
Views: 6719
|
|
|
dsc08966
Port side LG socket hole.
Date: 10/01/2012
Views: 11511
|
|
|
p1000696
p1000696.jpg
Date: 03/12/2012
Views: 6717
|
|
|
nex_2014_01_25_02
Starboard side of the air bubble fix on rib one. Used Flox with aeroboxy as a fillit.
Date: 01/25/2014
Views: 8357
|
|
|
2012-08-18_19-58-42_666
Port side. Same area as before just without the flash. Backlit from the inside to show areas with less material. This is before I did the belly layup per the manual.
Date: 08/19/2012
Views: 12206
|
|
|
p1000476
p1000476.jpg
Date: 12/13/2011
Views: 13714
|
|
|
DSC08796
Put in the panel to dream a little. Don't really know what I'm going to do. Was thinking of keeping it low cost for the first panel and keeping it analog until I can get the cash mula for something better like glass/IFR. Also want to fill the hole where
Date: 06/05/2012
Views: 12561
|
|
|
dsc08608
These will have to go. They are on top and I will remove them and put one vent on the bottom.
Date: 04/10/2012
Views: 13118
|
|
|
dsc09036
Rib one port side again used around 112g of 420 cured at 78f for 12 hours.
Date: 01/23/2013
Views: 9084
|
|
|
nex_2014_01_25_32
nex_2014_01_25_32.jpg
Date: 01/26/2014
Views: 10274
|
|
|
dsc08967
Little clean up required on Port side.
Date: 10/01/2012
Views: 10662
|
|
|
dsc08612
Unused Mono wheel components. I'll probably be selling these soon.
Date: 04/10/2012
Views: 12622
|
|
|
p1000689
p1000689.jpg
Date: 03/12/2012
Views: 7049
|
|
|
p1000687
p1000687.jpg
Date: 03/12/2012
Views: 6975
|
|
|
E2
Date: 10/05/2012
Views: 12754
|
|
|
dsc08964
Port side. Fitting of LG socket.
Date: 10/01/2012
Views: 10333
|
|
|
p1000615
p1000615.jpg
Date: 01/29/2012
Views: 10042
|
|