|
dsc08617
After removing the green tape.
Date: 04/14/2012
Views: 73129
|
|
|
dsc09062
Bill applying peel ply!
Date: 01/24/2013
Views: 9171
|
|
|
dsc08662
The 10“ diameter from the pilot hole.
Date: 04/22/2012
Views: 13392
|
|
|
dsc08619
Roap tied to the engine mount frame to hoist the airframe.
Date: 04/14/2012
Views: 17482
|
|
|
dsc08626
Put in a 2x4 in the main wing spar tunnel and located the pins. This was only used to aid in keeping the plane from tipping.
Date: 04/14/2012
Views: 12603
|
|
|
dsc09058
Wetting out stbd side.
Date: 01/24/2013
Views: 8694
|
|
|
dsc09076
Bottom layup of the port side.
Date: 01/26/2013
Views: 9213
|
|
|
20141102_153539
Out. Ad you can see the screw is sill in the nut plate. it came out later.
Date: 11/02/2014
Views: 19352
|
|
|
DSC08799
Port side
Date: 06/05/2012
Views: 10301
|
|
|
p1000707
p1000707.jpg
Date: 03/12/2012
Views: 6763
|
|
|
dsc09029
Gear legs clamped in place, no toe in/out per Bud. You cant see it in the photo but I used a green tip .30 bullet as a homemade plum bob that was attached to dead center of the aluminum angle. This helped us keep the guide over the center line. Oh make
Date: 01/22/2013
Views: 9515
|
|
|
dsc08963
Port side. LG socket fitting.
Date: 10/01/2012
Views: 10575
|
|
|
nex_2014_01_25_31
Starboard side, need to trim the bolt.
Date: 01/26/2014
Views: 9351
|
|
|
dsc08609
Underside of vents.
Date: 04/10/2012
Views: 13518
|
|
|
p1000709
p1000709.jpg
Date: 03/12/2012
Views: 6669
|
|
|
p1000716
p1000716.jpg
Date: 03/12/2012
Views: 6627
|
|
|
dsc09046
Making a layup schedule for rib 1.
Date: 01/23/2013
Views: 9325
|
|
|
dsc08642
From the start the airframe was sitting 2.5 deg tail low and 0.1 deg to port. Not bad for just putting her on there. I jacked up the back of the trailer to get it as near to 0.0 as possible and also shifted the airframe latterly to turn that .1 to 0.0 a
Date: 04/15/2012
Views: 12274
|
|
|
p1000730
p1000730.jpg
Date: 03/12/2012
Views: 6397
|
|
|
dsc08627
The monowheel landing gear is in the up position and resting on the main wheel with some of the weight held by the block and tackle. This was taken just before putting on the braces to keep her from rolling. Been trying to get rid of that tv in the back
Date: 04/14/2012
Views: 11780
|
|