|
IMG_0189[1]
Date: 04/13/2014
Views: 13429
|
|
|
IMG_0394
Date: 04/10/2015
Views: 9436
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 10298
|
|
|
IMG_0414
Date: 04/18/2015
Views: 11274
|
|
|
IMG_0228
Andy & I having a good breakfast prior to the start of our trip to South Wales
Date: 01/31/2014
Views: 11018
|
|
|
DSC00153
Lathe installed
Date: 09/01/2015
Views: 11734
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 9968
|
|
|
Ipad 044
Shed Complete
Date: 04/13/2014
Views: 10086
|
|
|
IMG_0392
Date: 04/10/2015
Views: 9120
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 8543
|
|
|
IMG_0187.JPG (2)
Workshop kitted out. All done in 3 weeks!
Date: 04/13/2014
Views: 12174
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 10321
|
|
|
IMG_0412
Date: 04/17/2015
Views: 10268
|
|
|
IMG_0191[1]
Date: 09/12/2015
Views: 10176
|
|
|
IMG_0409
Date: 04/17/2015
Views: 9416
|
|
|
IMG_0231
Date: 01/31/2014
Views: 10879
|
|
|
DSC00219
bracket installed
Date: 09/09/2015
Views: 12449
|
|
|
Ipad 041
Shed Under construction
Date: 03/27/2014
Views: 9801
|
|
|
IMG_0237
Fuselage in the truck
Date: 02/01/2014
Views: 10774
|
|
|
IMG_0390
Date: 04/10/2015
Views: 9326
|
|